Re: [PATCH v11 0/3] Add basic node support for MediaTek MT8186 SoC

[Matthias Brugger <matthias.bgg@gmail.com>]

On 22/06/2022 17:40, Matthias Brugger wrote:
> 
> 
> On 20/05/2022 14:22, Allen-KH Cheng wrote:
>> MT8186 is a SoC based on 64bit ARMv8 architecture.
>> It contains 6 CA55 and 2 CA76 cores.
>> MT8186 share many HW IP with MT65xx series.
>>
>> This patchset was tested on MT8186 evaluation board to shell.
>>
> 
> Applied, thanks!
> 

Based on the review from Angelo I dropped patch 3 from the tree. Please address 
the issues and submit again.

Regards,
Matthias

>> Based on next-20220519, linux-next/master
>>
>> changes since v9:
>>   - remove some merged PATCHs from series
>>   - reorder nodes in dts (cpu-map)
>>   - remove okay status in auxadc
>>   - remove unnecessary suffix node name for i2c
>>   - add pwm node
>>   - add dsi-phy node
>>   - add dpi node
>>
>> changes since v9:
>>   - add one space before equal sign of drive-strength-adv
>>   - corect compatible name for big cores (ca76)
>>   - use upper case of address in pinctrl
>>   - add pwrap node
>>   - add pwm node
>>
>> changes since v8:
>>   - change name from pins_bus to pins-sda-scl
>>   - correct email address
>>   - add capacity-dmips-mhz for each CPU
>>   - add ppi-partitions in gic node
>>   - change name to power-domain
>>   - remove status "okay" in scp node
>>   - update timer and pericfg compatible in series
>>
>> changes since v7:
>>   - add scp&auxadc node
>>
>> changes since v6:
>>   - remove unnecessary blank line
>>
>> changes since v5:
>>   - replace Mediatek a to MediaTek
>>   - use GPL-2.0-only OR BSD-2-Clause
>>
>> changes since v4:
>>   - correct driver clock of mt8186
>>   - add power domains controller and clock controllers
>>   - add pinctrl, usb host, spi and i2c nodes
>>   - add node status in mt8186-evb.dts
>>   - correct some dtbs_check warnings
>>
>> changes since v3:
>>   - remove serial, mmc and phy patch from series. (already merged)
>>   - remove mcusysoff node
>>   - move oscillator nodes at the head of dts
>>   - change name from usb-phy to t-phy
>>
>> changes since v2:
>>   - add soc {} in mt8186.dtsi
>>
>> changes since v1:
>>   - add dt-bindings: arm: Add compatible for MediaTek MT8186
>>
>> Allen-KH Cheng (3):
>>    dt-bindings: arm: mediatek: Add mt8186 pericfg compatible
>>    dt-bindings: arm: Add compatible for MediaTek MT8186
>>    arm64: dts: Add MediaTek SoC MT8186 dts and evaluation board and
>>      Makefile
>>
>>   .../devicetree/bindings/arm/mediatek.yaml     |    4 +
>>   .../arm/mediatek/mediatek,pericfg.yaml        |    1 +
>>   arch/arm64/boot/dts/mediatek/Makefile         |    1 +
>>   arch/arm64/boot/dts/mediatek/mt8186-evb.dts   |  232 ++++
>>   arch/arm64/boot/dts/mediatek/mt8186.dtsi      | 1016 +++++++++++++++++
>>   5 files changed, 1254 insertions(+)
>>   create mode 100644 arch/arm64/boot/dts/mediatek/mt8186-evb.dts
>>   create mode 100644 arch/arm64/boot/dts/mediatek/mt8186.dtsi
>>