From: Borsenkow Andrej <Andrej.Borsenkow@mow.siemens.ru>
To: linux-kernel list <linux-kernel@vger.kernel.org>
Subject: Re: 2.4.18-pre9, Iomega Jaz, PPA - endless loop in SCSI recovery thread
Date: 09 Jun 2002 00:58:00 +0400 [thread overview]
Message-ID: <1023569887.13619.9.camel@localhost.localdomain> (raw)
In-Reply-To: <1023569729.13619.6.camel@localhost.localdomain>
Oh, and when I tried to simply switch off Jaz during this loop I got
panic:
kernel panic: scsi_unjam_host
Miscount of number of failed commands
Not sure if it helps very much ...
-andrej
В Вск, 09.06.2002, в 00:55, Andrej Borsenkow написал:
>
> It looks like a media went corrupted so one expects some reasonable
> error message. What happens is I get endless loop in SCSI error recovery
> thread. The only way to clear up situation is to reboot and even then it
> hangs on umount so I have to do SysRq-B. Please, what additional
> information can be provided; I hope I can keep this media intact for
> some time for testing :-)
>
> the kernel is 2.4.18-18mdk based on 2.4.1-pre9.
>
> I am not on lkml so please Cc me. Thank you.
>
> -andrej
>
>
> {pts/0}% cat /proc/scsi/scsi
> Attached devices:
> Host: scsi0 Channel: 00 Id: 04 Lun: 00
> Vendor: iomega Model: jaz 2GB Rev: E.17
> Type: Direct-Access ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 03 Lun: 00
> Vendor: PHILIPS Model: CDD3610 CD-R/RW Rev: 3.09
> Type: CD-ROM ANSI SCSI revision: 02
> {pts/0}% cat /proc/scsi/ppa/0
> Version : 2.07 (for Linux 2.4.x)
> Parport : parport0
> Mode : EPP 32 bit
> {pts/0}% uname -a
> Linux localhost.localdomain 2.4.18-18mdkcustom #5 Sat Jun 8 23:25:23 MSD
> 2002 i686 unknown
>
> SCSI log:
>
> Jun 8 20:49:59 localhost kernel: Activating command for device 4 (1)
> Jun 8 20:49:59 localhost kernel: Doing sd request, dev = 0x804, block = 944344
> Jun 8 20:49:59 localhost kernel: sda : real dev = /dev/0, block = 944376
> Jun 8 20:49:59 localhost kernel: sda : reading 248/248 512 byte blocks.
> Jun 8 20:49:59 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12892)
> Jun 8 20:49:59 localhost kernel: scsi_dispatch_cmnd (host = 0, channel = 0, target = 4, command = cd8b1e58, buffer = c009e000,
> Jun 8 20:49:59 localhost kernel: bufflen = 126976, done = d2813b7a)
> Jun 8 20:49:59 localhost kernel: queuecommand : routine at d2a2f1e0
> Jun 8 20:49:59 localhost kernel: leaving scsi_dispatch_cmnd()
> Jun 8 20:50:00 localhost kernel: Clearing timer for command cd8b1e00 1
> Jun 8 20:50:00 localhost kernel: Command failed cd8b1e00 2 active=1 busy=1 failed=0
> Jun 8 20:50:00 localhost kernel: bh08:04: old sense key None
> Jun 8 20:50:00 localhost kernel: Non-extended sense class 0 code 0x0
> Jun 8 20:50:00 localhost kernel: Waking error handler thread (-1)
> Jun 8 20:50:00 localhost kernel: Error handler waking up
> Jun 8 20:50:00 localhost kernel: scsi_unjam_host: Checking to see if we need to request sense
> Jun 8 20:50:00 localhost kernel: scsi_unjam_host: Requesting sense for 4
> Jun 8 20:50:00 localhost kernel: Adding timer for command cd8b1e00 at 1000 (d2a12a28)
> Jun 8 20:50:00 localhost kernel: In eh_done cd8b1e00 result:0
> Jun 8 20:50:00 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:00 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2002
> Jun 8 20:50:00 localhost kernel: Sense requested for cd8b1e00 - result 2
> Jun 8 20:50:00 localhost kernel: Info fld=0xe6960, Current bh08:04: sense key Medium Error
> Jun 8 20:50:00 localhost kernel: Additional sense indicates Address mark not found for data field
> Jun 8 20:50:00 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:03 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:03 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:03 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:03 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:06 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:06 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:06 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:06 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:09 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:09 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:09 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:09 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:12 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:12 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:12 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:12 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:15 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:15 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:15 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:15 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:17 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:17 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:17 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:17 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:20 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:20 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:20 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:20 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:23 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:23 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:23 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:23 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:26 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:26 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:26 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
next prev parent reply other threads:[~2002-06-08 21:00 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-06-08 20:55 2.4.18-pre9, Iomega Jaz, PPA - endless loop in SCSI recovery thread Borsenkow Andrej
2002-06-08 20:58 ` Borsenkow Andrej [this message]
-- strict thread matches above, loose matches on Subject: below --
2002-06-08 22:50 Andries.Brouwer
2002-06-09 16:04 ` Borsenkow Andrej
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1023569887.13619.9.camel@localhost.localdomain \
--to=andrej.borsenkow@mow.siemens.ru \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox