Am Mon, 2003-03-17 um 00.37 schrieb Daniel Egger:

> I tried to figure out what's wrong and it seems that the make machinery
> is not up-to-date since none of the code in question is dependent on
> the definition of MODULE or alike.

Being a big fan of quoting myself; the above statement is not entirely
accurate. This is the error I get when

"ATA/ATAPI/MFM/RLL device support" is built in and
"Enhanced IDE/MFM/RLL disk/cdrom/tape/floppy support" built as module

In case both are built as module I get:
*** Warning: "ide_pci_unregister_driver" [drivers/ide/pci/sis5513.ko] undefined!
*** Warning: "ide_pci_register_driver" [drivers/ide/pci/sis5513.ko] undefined!
*** Warning: "ide_setup_pci_device" [drivers/ide/pci/sis5513.ko] undefined!
*** Warning: "ide_setup_dma" [drivers/ide/pci/sis5513.ko] undefined!
*** Warning: "ide_pci_register_host_proc" [drivers/ide/pci/sis5513.ko] undefined!
*** Warning: "proc_ide_destroy" [drivers/ide/ide.ko] undefined!
*** Warning: "ide_remove_proc_entries" [drivers/ide/ide.ko] undefined!
*** Warning: "ide_add_proc_entries" [drivers/ide/ide.ko] undefined!
*** Warning: "proc_ide_create" [drivers/ide/ide.ko] undefined!
*** Warning: "ide_scan_pcibus" [drivers/ide/ide.ko] undefined!
*** Warning: "create_proc_ide_interfaces" [drivers/ide/ide.ko] undefined!
*** Warning: "ide_release_dma" [drivers/ide/ide.ko] undefined!
*** Warning: "destroy_proc_ide_drives" [drivers/ide/ide.ko] undefined!
*** Warning: "proc_ide_read_capacity" [drivers/ide/ide.ko] undefined!
*** Warning: "ide_xlate_1024" [drivers/ide/ide-probe.ko] undefined!
*** Warning: "create_proc_ide_interfaces" [drivers/ide/ide-probe.ko] undefined!
*** Warning: "ide_bus_type" [drivers/ide/ide-probe.ko] undefined!
*** Warning: "ide_add_generic_settings" [drivers/ide/ide-probe.ko] undefined!
*** Warning: "do_ide_request" [drivers/ide/ide-probe.ko] undefined!
*** Warning: "proc_ide_read_geometry" [drivers/ide/ide-disk.ko] undefined!

Is there a reason that no entries of "IDE, ATA and ATAPI Block devices"
are not being merged into "ATA/ATAPI/MFM/RLL device support"?

-- 
Servus,
       Daniel