Re: [PATCH-2.5] Fix w83781d sensor to use Milli-Volt for in_* in sysfs

[Martin Schlemmer <azarah@gentoo.org>]

On Wed, 2003-04-09 at 00:04, Greg KH wrote:

> Oh, I'm getting the following warning when building the driver, want to
> look into this?
> 
> drivers/i2c/chips/w83781d.c: In function `store_fan_div_reg':
> drivers/i2c/chips/w83781d.c:715: warning: `old3' might be used uninitialized in this function
>   

It is because old3 is only referenced if:

 ((data->type != w83781d) && data->type != as99127f)

as those two chips don't have extended divisor bits ...

It is however set in the first occurrence:

---------------------------------------------------------------------
       /* w83781d and as99127f don't have extended divisor bits */
       if ((data->type != w83781d) && data->type != as99127f) {
               old3 = w83781d_read_value(client, W83781D_REG_VBAT);
       }
---------------------------------------------------------------------

and thus is rather gcc being brain dead for not being able to figure
old3 is only used within a if block like that.

I was not sure about style policy in a case like this, so I left it as
is, it should however be possible to 'fix' it with:


--- 1/drivers/i2c/chips/w83781d.c	2003-04-09 08:16:08.000000000 +0200
+++ 2/drivers/i2c/chips/w83781d.c	2003-04-09 08:16:22.000000000 +0200
@@ -712,7 +712,7 @@
 {
 	struct i2c_client *client = to_i2c_client(dev);
 	struct w83781d_data *data = i2c_get_clientdata(client);
-	u32 val, old, old2, old3;
+	u32 val, old, old2, old3 = 0;
 
 	val = simple_strtoul(buf, NULL, 10);
 	old = w83781d_read_value(client, W83781D_REG_VID_FANDIV);


Regards,

-- 
Martin Schlemmer