[netdev watchdog/b44] is something broken?

[netdev watchdog/b44] is something broken?

[Ian Kumlien]

[-- Attachment #1: Type: text/plain, Size: 1231 bytes --]

Hi, 

I mailed before about dlinks 4 port alta card using sundance... 

Now i'm trying to transfer some data to my laptop and after about 1
minute of ~12mb/s this happens:

NETDEV WATCHDOG: eth0: transmit timed out
b44: eth0: transmit timed out, resetting
b44: eth0: Link is down.
eth0: no IPv6 routers present
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is on for TX and on for RX.

This is a udp link, but i disabled all tcp tweaks that i have been
playing with as well. Btw, this worked just fine for a while, then this
started. (tcp tweaks like westwood and bic)

Imho something is wrong with the watchdog (or the staircase scheduler
7.1 changes some behavior that the watchdog is depending on... Other
than that this is a pure 2.6.7 kernel)

Any comments clues suggestions?

I'm copying this to a firewire disk if that could have any
implications... But after seeing this in the sundance driver i'm
assuming that something else is broken.

Just prior to the watchdog timeout the transfer seems to act like a sine
wave, ie 8mb/s -> 533 b/s -> 12 mb/s -> 733b/s -> etc
(observations from gkrellm)

-- 
Ian Kumlien <pomac () vapor ! com> -- http://pomac.netswarm.net

[-- Attachment #2: This is a digitally signed message part --]
[-- Type: application/pgp-signature, Size: 189 bytes --]