* Problem: USB phone not detected after disconnect/reconnect
@ 2006-01-03 21:37 Rob Dyck
2006-01-05 22:06 ` Lee Revell
0 siblings, 1 reply; 2+ messages in thread
From: Rob Dyck @ 2006-01-03 21:37 UTC (permalink / raw)
To: linux-kernel
When USB phone is disconnected and then reconnected the system sometimes does
not detect it. Another device such as storage is not detected either. I am
not positive but the problem seems to occur if the USB phone was connected
during the boot. I do not know if it is relevant but I use APM not ACPI.
Some information I have gathered.
This is the device
usb 3-1: new device strings: Mfr=1, Product=2, SerialNumber=4
usb 3-1: Product: USB Phone
usb 3-1: Manufacturer: BeyondTel
usb 3-1: SerialNumber: 0001
Good disconnect. Four interfaces unregistered.
usb 3-1: USB disconnect, address 7
usb 3-1: usb_disable_device nuking all URBs
usb 3-1: unregistering interface 3-1:1.0
usb 3-1:1.0: hotplug
usb 3-1: unregistering interface 3-1:1.1
usb 3-1:1.1: hotplug
usb 3-1: unregistering interface 3-1:1.2
usb 3-1:1.2: hotplug
usb 3-1: unregistering interface 3-1:1.3
drivers/usb/core/file.c: removing 96 minor
usb 3-1:1.3: hotplug
usb 3-1: unregistering device
usb 3-1: hotplug
hub 3-0:1.0: debounce: port 1: total 100ms stable 100ms status 0x100
uhci_hcd 0000:00:10.1: suspend_rh (auto-stop)
Bad disconnect. interfaces 1.1 1.2 and 1.3 not unregistered
usb 3-1: USB disconnect, address 2
usb 3-1: usb_disable_device nuking all URBs
usb 3-1: unregistering interface 3-1:1.0
uhci_hcd 0000:00:10.1: suspend_rh (auto-stop)
Also /var/log/hotplug/events shows that the OSS audio devices were removed on
disconnect but the ALSA devices were not. The problem is not specific to
2.6.15 however I do not know when it started. Perhaps it has always been a
problem in USB.
Linux fatboy.mylan 2.6.15 #1 PREEMPT Tue Jan 3 11:49:30 PST 2006 i686 athlon
i386 GNU/Linux
Gnu C 3.4.2
Gnu make 3.80
binutils 2.15.92.0.2
util-linux 2.12a
mount 2.12a
module-init-tools 3.1-pre5
e2fsprogs 1.35
reiserfsprogs line
reiser4progs line
pcmcia-cs 3.2.7
quota-tools 3.12.
PPP 2.4.2
isdn4k-utils 3.3
nfs-utils 1.0.6
Linux C Library 2.3.3
Dynamic linker (ldd) 2.3.3
Procps 3.2.3
Net-tools 1.60
Kbd 1.12
Sh-utils 5.2.1
udev 075
Modules Loaded parport_pc lp parport autofs4 nfs lockd sunrpc
af_packet usbhid uhci_hcd ehci_hcd snd_via82xx snd_ac97_codec snd_ac97_bus
snd_mpu401_uart snd_usb_audio snd_pcm_oss snd_mixer_oss snd_pcm snd_timer
snd_page_alloc snd_usb_lib snd_rawmidi snd_hwdep snd soundcore
Keywords - USB, hotplug
Output of lspci
00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400/KT600 AGP] Host
Bridge
00:01.0 PCI bridge: VIA Technologies, Inc. VT8235 PCI Bridge
00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
Controller (rev 80)
00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
Controller (rev 80)
00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
Controller (rev 80)
00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
00:11.1 IDE interface: VIA Technologies, Inc.
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237
AC97 Audio Controller (rev 50)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74)
01:00.0 VGA compatible controller: nVidia Corporation NV5M64 [RIVA TNT2 Model
64/Model 64 Pro] (rev 15)
lsusb just hangs.
^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: Problem: USB phone not detected after disconnect/reconnect
2006-01-03 21:37 Problem: USB phone not detected after disconnect/reconnect Rob Dyck
@ 2006-01-05 22:06 ` Lee Revell
0 siblings, 0 replies; 2+ messages in thread
From: Lee Revell @ 2006-01-05 22:06 UTC (permalink / raw)
To: Rob Dyck; +Cc: linux-kernel, linux-usb-devel, alsa-devel
[added alsa-devel and linux-usb-devel to cc]
I have seen similar bug reports from other users. This one seems to
affect the USB storage and USB audio devices, is it a bug in the host
controller?
On Tue, 2006-01-03 at 13:37 -0800, Rob Dyck wrote:
> When USB phone is disconnected and then reconnected the system sometimes does
> not detect it. Another device such as storage is not detected either. I am
> not positive but the problem seems to occur if the USB phone was connected
> during the boot. I do not know if it is relevant but I use APM not ACPI.
>
> Some information I have gathered.
> This is the device
> usb 3-1: new device strings: Mfr=1, Product=2, SerialNumber=4
> usb 3-1: Product: USB Phone
> usb 3-1: Manufacturer: BeyondTel
> usb 3-1: SerialNumber: 0001
>
> Good disconnect. Four interfaces unregistered.
>
> usb 3-1: USB disconnect, address 7
> usb 3-1: usb_disable_device nuking all URBs
> usb 3-1: unregistering interface 3-1:1.0
> usb 3-1:1.0: hotplug
> usb 3-1: unregistering interface 3-1:1.1
> usb 3-1:1.1: hotplug
> usb 3-1: unregistering interface 3-1:1.2
> usb 3-1:1.2: hotplug
> usb 3-1: unregistering interface 3-1:1.3
> drivers/usb/core/file.c: removing 96 minor
> usb 3-1:1.3: hotplug
> usb 3-1: unregistering device
> usb 3-1: hotplug
> hub 3-0:1.0: debounce: port 1: total 100ms stable 100ms status 0x100
> uhci_hcd 0000:00:10.1: suspend_rh (auto-stop)
>
> Bad disconnect. interfaces 1.1 1.2 and 1.3 not unregistered
>
> usb 3-1: USB disconnect, address 2
> usb 3-1: usb_disable_device nuking all URBs
> usb 3-1: unregistering interface 3-1:1.0
> uhci_hcd 0000:00:10.1: suspend_rh (auto-stop)
>
> Also /var/log/hotplug/events shows that the OSS audio devices were removed on
> disconnect but the ALSA devices were not. The problem is not specific to
> 2.6.15 however I do not know when it started. Perhaps it has always been a
> problem in USB.
>
> Linux fatboy.mylan 2.6.15 #1 PREEMPT Tue Jan 3 11:49:30 PST 2006 i686 athlon
> i386 GNU/Linux
>
> Gnu C 3.4.2
> Gnu make 3.80
> binutils 2.15.92.0.2
> util-linux 2.12a
> mount 2.12a
> module-init-tools 3.1-pre5
> e2fsprogs 1.35
> reiserfsprogs line
> reiser4progs line
> pcmcia-cs 3.2.7
> quota-tools 3.12.
> PPP 2.4.2
> isdn4k-utils 3.3
> nfs-utils 1.0.6
> Linux C Library 2.3.3
> Dynamic linker (ldd) 2.3.3
> Procps 3.2.3
> Net-tools 1.60
> Kbd 1.12
> Sh-utils 5.2.1
> udev 075
> Modules Loaded parport_pc lp parport autofs4 nfs lockd sunrpc
> af_packet usbhid uhci_hcd ehci_hcd snd_via82xx snd_ac97_codec snd_ac97_bus
> snd_mpu401_uart snd_usb_audio snd_pcm_oss snd_mixer_oss snd_pcm snd_timer
> snd_page_alloc snd_usb_lib snd_rawmidi snd_hwdep snd soundcore
>
> Keywords - USB, hotplug
>
> Output of lspci
> 00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400/KT600 AGP] Host
> Bridge
> 00:01.0 PCI bridge: VIA Technologies, Inc. VT8235 PCI Bridge
> 00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
> Controller (rev 80)
> 00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
> Controller (rev 80)
> 00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1
> Controller (rev 80)
> 00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
> 00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
> 00:11.1 IDE interface: VIA Technologies, Inc.
> VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
> 00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237
> AC97 Audio Controller (rev 50)
> 00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74)
> 01:00.0 VGA compatible controller: nVidia Corporation NV5M64 [RIVA TNT2 Model
> 64/Model 64 Pro] (rev 15)
>
> lsusb just hangs.
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
>
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2006-01-05 22:06 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2006-01-03 21:37 Problem: USB phone not detected after disconnect/reconnect Rob Dyck
2006-01-05 22:06 ` Lee Revell
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox