[PATCH 16/20] Blackfin serial driver: ignore framing and parity errors

[Bryan Wu <bryan.wu@analog.com>]

From: Mike Frysinger <michael.frysinger@analog.com>

if we get a break signal, we want to ignore framing and parity errors
because those will always be set (by nature of the signal)

Signed-off-by: Mike Frysinger <michael.frysinger@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
---
 drivers/serial/bfin_5xx.c |    2 ++
 1 files changed, 2 insertions(+), 0 deletions(-)

diff --git a/drivers/serial/bfin_5xx.c b/drivers/serial/bfin_5xx.c
index aeb3cc2..9d356fc 100644
--- a/drivers/serial/bfin_5xx.c
+++ b/drivers/serial/bfin_5xx.c
@@ -185,6 +185,7 @@ static void bfin_serial_rx_chars(struct bfin_serial_port *uart)
 		uart->port.icount.brk++;
 		if (uart_handle_break(&uart->port))
 			goto ignore_char;
+		status &= ~(PE | FE);
 	}
 	if (status & PE)
 		uart->port.icount.parity++;
@@ -341,6 +342,7 @@ static void bfin_serial_dma_rx_chars(struct bfin_serial_port *uart)
 		uart->port.icount.brk++;
 		if (uart_handle_break(&uart->port))
 			goto dma_ignore_char;
+		status &= ~(PE | FE);
 	}
 	if (status & PE)
 		uart->port.icount.parity++;
-- 
1.5.2