[BUG] libata IT821X driver still fails! Hard-freezes system.

[BUG] libata IT821X driver still fails! Hard-freezes system.

[Rodney Gordon II]

This is the screen image I took with my digital camera when bootup
freezes:
http://spherevision.org/sync/visual/itefreeze.jpg

After this freeze, not even SysRq commands work.
On a side-note, the non-libata drivers boot up, but throw tons of DMA
errors after one DVD burn.

The kernel I tested this on (newest I would try) is 2.6.22-rc4 with and
without cfs16. I am willing to test out patches if I can get this darn
controller working.

My config: http://spherevision.org/sync/tmp/dot.config

At the time of this freeze, the kernel was not tainted. I am running a
Pentium-D 830 3.0GHz Dualcore on a ASUS P5LD2 with latest bios rev.
1804.

My lspci -vvv info: http://spherevision.org/sync/tmp/lspci.out

I also find it pecular that it says there is a 40wire cable; I have
tried 3 different 80wire cables and it doesn't make a difference. So,
yes indeed I am using proper cables, and have tried others.

Just to make sure, this a brand new 20A1P burner, the old one did the
same thing though.

If I build pata_821x(or whatnot) as a module, system freezes after about
5 seconds after insmod, without dumping any information at all. 

It may say it's a RAID controller, but on this motherboard it seems to
be pure passthru because there is no RAID option for this controller in
the BIOS. I have also tried a few flags recommended by Alan before,
which do not help.

Help would be very much appreciated! Further info, if needed, just ask.

-r

Re: [BUG] libata IT821X driver still fails! Hard-freezes system.

[Tejun Heo]

Rodney Gordon II wrote:
> This is the screen image I took with my digital camera when bootup
> freezes:
> http://spherevision.org/sync/visual/itefreeze.jpg
> 
> After this freeze, not even SysRq commands work.
> On a side-note, the non-libata drivers boot up, but throw tons of DMA
> errors after one DVD burn.
> 
> The kernel I tested this on (newest I would try) is 2.6.22-rc4 with and
> without cfs16. I am willing to test out patches if I can get this darn
> controller working.

Does ide it821x driver work?  (drivers -> ata/atapi/mfm/rll support ->
it821x ide support)

-- 
tejun