[PATCH 10/20] Blackfin SPI Driver: use the properl BIT_CTL_xxx defines

[Bryan Wu <cooloney@kernel.org>]

From: Mike Frysinger <vapier.adi@gmail.com>

use the properl BIT_CTL_... defines rather than the internal driv
er CFG_SPI_... defines

Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
---
 drivers/spi/spi_bfin5xx.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
index f7a4b5b..54d8948 100644
--- a/drivers/spi/spi_bfin5xx.c
+++ b/drivers/spi/spi_bfin5xx.c
@@ -799,7 +799,7 @@ static void pump_transfers(unsigned long data)
 
 			/* start SPI transfer */
 			write_CTRL(drv_data,
-				(cr | CFG_SPI_DMAWRITE | BIT_CTL_ENABLE));
+				(cr | BIT_CTL_TIMOD_DMA_TX | BIT_CTL_ENABLE));
 
 			/* just return here, there can only be one transfer
 			 * in this mode
@@ -827,7 +827,7 @@ static void pump_transfers(unsigned long data)
 
 			dma_config |= WNR;
 			dma_start_addr = (unsigned long)drv_data->rx;
-			cr |= CFG_SPI_DMAREAD;
+			cr |= BIT_CTL_TIMOD_DMA_RX | BIT_CTL_SENDOPT;
 
 		} else if (drv_data->tx != NULL) {
 			dev_dbg(&drv_data->pdev->dev, "doing DMA out.\n");
@@ -839,7 +839,7 @@ static void pump_transfers(unsigned long data)
 						drv_data->len_in_bytes));
 
 			dma_start_addr = (unsigned long)drv_data->tx;
-			cr |= CFG_SPI_DMAWRITE;
+			cr |= BIT_CTL_TIMOD_DMA_TX;
 
 		} else
 			BUG();
-- 
1.5.6.3