[RFC PATCH 3/4] x86: using logical flat for amd cpu too.

[Yinghai Lu <yinghai@kernel.org>]

not sure it works again, could be bios fix the irq routing dest ?

tested that amd support logical flat too when cpus num <= 8 and even
bsp apic id > 8

so could remove vendor check...

Signed-off-by: Yinghai Lu <yinghai@kernel.org>

---
 arch/x86/kernel/apic/apic.c     |   11 ++---------
 arch/x86/kernel/apic/probe_64.c |   13 ++-----------
 2 files changed, 4 insertions(+), 20 deletions(-)

Index: linux-2.6/arch/x86/kernel/apic/apic.c
===================================================================
--- linux-2.6.orig/arch/x86/kernel/apic/apic.c
+++ linux-2.6/arch/x86/kernel/apic/apic.c
@@ -1898,15 +1898,8 @@ void __cpuinit generic_processor_info(in
 		max_physical_apicid = apicid;
 
 #ifdef CONFIG_X86_32
-	switch (boot_cpu_data.x86_vendor) {
-	case X86_VENDOR_INTEL:
-		if (num_processors > 8)
-			def_to_bigsmp = 1;
-		break;
-	case X86_VENDOR_AMD:
-		if (max_physical_apicid >= 8)
-			def_to_bigsmp = 1;
-	}
+	if (num_processors > 8)
+		def_to_bigsmp = 1;
 #endif
 
 #if defined(CONFIG_SMP) || defined(CONFIG_X86_64)
Index: linux-2.6/arch/x86/kernel/apic/probe_64.c
===================================================================
--- linux-2.6.orig/arch/x86/kernel/apic/probe_64.c
+++ linux-2.6/arch/x86/kernel/apic/probe_64.c
@@ -67,17 +67,8 @@ void __init default_setup_apic_routing(v
 	}
 #endif
 
-	if (apic == &apic_flat) {
-		switch (boot_cpu_data.x86_vendor) {
-		case X86_VENDOR_INTEL:
-			if (num_processors > 8)
-				apic = &apic_physflat;
-			break;
-		case X86_VENDOR_AMD:
-			if (max_physical_apicid >= 8)
-				apic = &apic_physflat;
-		}
-	}
+	if (apic == &apic_flat && num_processors > 8)
+		apic = &apic_physflat;
 
 	printk(KERN_INFO "Setting APIC routing to %s\n", apic->name);