Re: Fwd: UEFI Secure boot using qemu-kvm

[joeyli <jlee@suse.com>]

Hi James, 

於 四，2012-06-28 於 18:11 +0800，lee joey 提到：
> 
> 
> ---------- Forwarded message ----------
> From: joeyli <jlee@suse.com>
> Date: 2012/6/28
> Subject: Re: UEFI Secure boot using qemu-kvm
> To: JBottomley@parallels.com
> Cc: linux-kernel@vger.kernel.org
> 
> 
> Hi James,
> 
> On Wed, Jun 27, 2012 at 06:34:05PM +0100, James Bottomley wrote:
> 
> > The purpose of this email is to widen the pool of people who are
> playing
> > with UEFI Secure boot.  The Linux Foundation Technical Advisory
> Board
> > have been looking into this because it turns out to be rather
> difficult
> > to lay your hands on real UEFI Secure Boot enabled hardware.
> 
> 
> 
> I am following your approach to reproduce your UEFI environment with
> qemu-kvm. After run qemu-system-x86_64 the kvm launched and go to UEFI
> shell success. So far so good!
> 
> But, I got a problem is the keyboard layout is not US keyboard, So I
> need build a mapping table for reference when key-in any letter:
> 
> [               e
> /               x
> s               i
> enter           t
> down            enter
> page up         down
> ...
> 
> 
> Did you meet this issue on your side?
> 

I just found this issue only happen on when I used ssh connect to the
machine that setup environment then run qemu-kvm.

When direct launch qemu-kvm on the machine, there have no keyboard
layout problem. Not sure this problem is dependent to qemu or UEFI
image.


Thanks a lot!
Joey Lee