[PATCH v2] scsi: virtio-scsi: Fix address translation failure of HighMem pages used by sg list

[Wang Sen <senwang@linux.vnet.ibm.com>]

When using the commands below to write some data to a virtio-scsi LUN of the
QEMU guest(32-bit) with 1G physical memory(qemu -m 1024), the qemu will crash.

        # sudo mkfs.ext4 /dev/sdb  (/dev/sdb is the virtio-scsi LUN.)
        # sudo mount /dev/sdb /mnt
        # dd if=/dev/zero of=/mnt/file bs=1M count=1024

In current implementation, sg_set_buf is called to add buffers to sg list which
is put into the virtqueue eventually. But if there are some HighMem pages in
table->sgl you can not get virtual address by sg_virt. So, sg_virt(sg_elem) may
return NULL value. This will cause QEMU exit when virtqueue_map_sg is called
in QEMU because an invalid GPA is passed by virtqueue.

I take Paolo's solution mentioned in last thread to avoid failure on handling 
flag bits.

I have tested the patch on my workstation. QEMU would not crash any more.

Signed-off-by: Wang Sen <senwang@linux.vnet.ibm.com>
---
 drivers/scsi/virtio_scsi.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/scsi/virtio_scsi.c b/drivers/scsi/virtio_scsi.c
index 1b38431..6661610 100644
--- a/drivers/scsi/virtio_scsi.c
+++ b/drivers/scsi/virtio_scsi.c
@@ -198,7 +198,7 @@ static void virtscsi_map_sgl(struct scatterlist *sg, unsigned int *p_idx,
 	int i;
 
 	for_each_sg(table->sgl, sg_elem, table->nents, i)
-		sg_set_buf(&sg[idx++], sg_virt(sg_elem), sg_elem->length);
+		sg[idx++] = *sg_elem;
 
 	*p_idx = idx;
 }
-- 
1.7.9.5