From: Yinghai Lu <yinghai@kernel.org>
To: Thomas Gleixner <tglx@linutronix.de>, Ingo Molnar <mingo@elte.hu>,
"H. Peter Anvin" <hpa@zytor.com>, Jacob Shin <jacob.shin@amd.com>,
Tejun Heo <tj@kernel.org>
Cc: linux-kernel@vger.kernel.org, Yinghai Lu <yinghai@kernel.org>
Subject: [PATCH 06/13] x86, mm: Separate out calculate_table_space_size()
Date: Sun, 30 Sep 2012 00:57:17 -0700 [thread overview]
Message-ID: <1348991844-12285-7-git-send-email-yinghai@kernel.org> (raw)
In-Reply-To: <1348991844-12285-1-git-send-email-yinghai@kernel.org>
It should take physical address range that will need to be mapped.
find_early_table_space should take range that pgt buff should be in.
Separating page table size calculating and finding early page table will
reduce confusing.
Signed-off-by: Yinghai Lu <yinghai@kernel.org>
Reviewed-by: Pekka Enberg <penberg@kernel.org>
---
arch/x86/mm/init.c | 39 ++++++++++++++++++++++++++++-----------
1 files changed, 28 insertions(+), 11 deletions(-)
diff --git a/arch/x86/mm/init.c b/arch/x86/mm/init.c
index d364f6a..dc05416 100644
--- a/arch/x86/mm/init.c
+++ b/arch/x86/mm/init.c
@@ -37,11 +37,10 @@ struct map_range {
static int page_size_mask;
-static void __init find_early_table_space(unsigned long begin,
+static unsigned long __init calculate_table_space_size(unsigned long begin,
unsigned long end)
{
- unsigned long puds, pmds, ptes, tables, start = 0, good_end = end;
- phys_addr_t base;
+ unsigned long puds, pmds, ptes, tables;
puds = (end + PUD_SIZE - 1) >> PUD_SHIFT;
tables = roundup(puds * sizeof(pud_t), PAGE_SIZE);
@@ -76,9 +75,17 @@ static void __init find_early_table_space(unsigned long begin,
#ifdef CONFIG_X86_32
/* for fixmap */
tables += roundup(__end_of_fixed_addresses * sizeof(pte_t), PAGE_SIZE);
- good_end = max_pfn_mapped << PAGE_SHIFT;
#endif
+ return tables;
+}
+
+static void __init find_early_table_space(unsigned long start,
+ unsigned long good_end,
+ unsigned long tables)
+{
+ phys_addr_t base;
+
base = memblock_find_in_range(start, good_end, tables, PAGE_SIZE);
if (!base)
panic("Cannot find space for the kernel page tables");
@@ -86,10 +93,6 @@ static void __init find_early_table_space(unsigned long begin,
pgt_buf_start = base >> PAGE_SHIFT;
pgt_buf_end = pgt_buf_start;
pgt_buf_top = pgt_buf_start + (tables >> PAGE_SHIFT);
-
- printk(KERN_DEBUG "kernel direct mapping tables up to %#lx @ [mem %#010lx-%#010lx]\n",
- end - 1, pgt_buf_start << PAGE_SHIFT,
- (pgt_buf_top << PAGE_SHIFT) - 1);
}
static void __init probe_page_size_mask(void)
@@ -282,6 +285,8 @@ unsigned long __init_refok init_memory_mapping(unsigned long start,
void __init init_mem_mapping(void)
{
+ unsigned long tables, good_end, end;
+
probe_page_size_mask();
/*
@@ -292,10 +297,18 @@ void __init init_mem_mapping(void)
* nodes are discovered.
*/
#ifdef CONFIG_X86_64
- find_early_table_space(0, max_pfn<<PAGE_SHIFT);
+ end = max_pfn << PAGE_SHIFT;
+ good_end = end;
#else
- find_early_table_space(0, max_low_pfn<<PAGE_SHIFT);
+ end = max_low_pfn << PAGE_SHIFT;
+ good_end = max_pfn_mapped << PAGE_SHIFT;
#endif
+ tables = calculate_table_space_size(0, end);
+ find_early_table_space(0, good_end, tables);
+ printk(KERN_DEBUG "kernel direct mapping tables up to %#lx @ [mem %#010lx-%#010lx] prealloc\n",
+ end - 1, pgt_buf_start << PAGE_SHIFT,
+ (pgt_buf_top << PAGE_SHIFT) - 1);
+
max_low_pfn_mapped = init_memory_mapping(0, max_low_pfn<<PAGE_SHIFT);
max_pfn_mapped = max_low_pfn_mapped;
@@ -322,9 +335,13 @@ void __init init_mem_mapping(void)
* RO all the pagetable pages, including the ones that are beyond
* pgt_buf_end at that time.
*/
- if (pgt_buf_end > pgt_buf_start)
+ if (pgt_buf_end > pgt_buf_start) {
+ printk(KERN_DEBUG "kernel direct mapping tables up to %#lx @ [mem %#010lx-%#010lx] final\n",
+ end - 1, pgt_buf_start << PAGE_SHIFT,
+ (pgt_buf_end << PAGE_SHIFT) - 1);
x86_init.mapping.pagetable_reserve(PFN_PHYS(pgt_buf_start),
PFN_PHYS(pgt_buf_end));
+ }
/* stop the wrong using */
pgt_buf_top = 0;
--
1.7.7
next prev parent reply other threads:[~2012-09-30 7:59 UTC|newest]
Thread overview: 57+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-09-30 7:57 [PATCH -v4 00/13] x86, mm: init_memory_mapping cleanup Yinghai Lu
2012-09-30 7:57 ` [PATCH 01/13] x86, mm: Add global page_size_mask and probe one time only Yinghai Lu
2012-09-30 7:57 ` [PATCH 02/13] x86, mm: Split out split_mem_range from init_memory_mapping Yinghai Lu
2012-09-30 7:57 ` [PATCH 03/13] x86, mm: Move init_memory_mapping calling out of setup.c Yinghai Lu
2012-09-30 7:57 ` [PATCH 04/13] x86, mm: Revert back good_end setting for 64bit Yinghai Lu
2012-10-01 11:00 ` Stefano Stabellini
2012-10-03 16:51 ` Jacob Shin
2012-10-03 18:34 ` H. Peter Anvin
2012-10-04 13:56 ` Konrad Rzeszutek Wilk
2012-10-04 21:52 ` H. Peter Anvin
2012-10-04 16:19 ` Yinghai Lu
2012-10-04 16:46 ` Konrad Rzeszutek Wilk
2012-10-04 21:29 ` Yinghai Lu
2012-10-05 21:04 ` Eric W. Biederman
2012-10-05 21:19 ` Yinghai Lu
2012-10-05 21:32 ` Eric W. Biederman
2012-10-05 21:37 ` Yinghai Lu
2012-10-05 21:41 ` Eric W. Biederman
2012-10-05 21:43 ` Yinghai Lu
2012-10-05 22:01 ` 896MB address limit (was: Re: [PATCH 04/13] x86, mm: Revert back good_end setting for 64bit) Eric W. Biederman
2012-10-06 0:18 ` [PATCH 04/13] x86, mm: Revert back good_end setting for 64bit H. Peter Anvin
2012-10-06 0:45 ` Eric W. Biederman
2012-10-06 1:02 ` H. Peter Anvin
2012-10-06 0:17 ` H. Peter Anvin
2012-10-06 0:28 ` Eric W. Biederman
2012-10-06 0:36 ` H. Peter Anvin
2012-10-04 15:57 ` Yinghai Lu
2012-10-04 16:45 ` Konrad Rzeszutek Wilk
2012-10-04 21:21 ` Yinghai Lu
2012-10-04 21:40 ` Yinghai Lu
2012-10-04 21:41 ` H. Peter Anvin
2012-10-04 21:46 ` Yinghai Lu
2012-10-04 21:54 ` H. Peter Anvin
2012-10-05 7:46 ` Yinghai Lu
2012-10-05 11:27 ` Stefano Stabellini
2012-10-05 14:58 ` Yinghai Lu
2012-10-06 7:44 ` [PATCH 0/3] x86: pre mapping page table to make xen happy Yinghai Lu
2012-10-06 7:44 ` [PATCH 1/3] x86: get early page table from BRK Yinghai Lu
2012-10-08 12:09 ` Stefano Stabellini
2012-10-06 7:44 ` [PATCH 2/3] x86, mm: Don't clear page table if next range is ram Yinghai Lu
2012-10-09 15:46 ` Konrad Rzeszutek Wilk
2012-10-10 1:00 ` Yinghai Lu
2012-10-10 13:41 ` Konrad Rzeszutek Wilk
2012-10-10 14:43 ` Yinghai Lu
2012-10-06 7:44 ` [PATCH 3/3] x86, mm: Remove early_memremap workaround for page table accessing Yinghai Lu
2012-10-09 15:48 ` Konrad Rzeszutek Wilk
2012-10-08 6:36 ` [PATCH 04/13] x86, mm: Revert back good_end setting for 64bit Yinghai Lu
2012-10-05 10:47 ` Stefano Stabellini
2012-09-30 7:57 ` [PATCH 05/13] x86, mm: Find early page table buffer altogether Yinghai Lu
2012-09-30 7:57 ` Yinghai Lu [this message]
2012-09-30 7:57 ` [PATCH 07/13] x86, mm: Move down two calculate_table_space_size down Yinghai Lu
2012-09-30 7:57 ` [PATCH 08/13] x86, mm: Set memblock initial limit to 1M Yinghai Lu
2012-09-30 7:57 ` [PATCH 09/13] x86: if kernel .text .data .bss are not marked as E820_RAM, complain and fix Yinghai Lu
2012-09-30 7:57 ` [PATCH 10/13] x86: Fixup code testing if a pfn is direct mapped Yinghai Lu
2012-09-30 7:57 ` [PATCH 11/13] x86: Only direct map addresses that are marked as E820_RAM Yinghai Lu
2012-09-30 7:57 ` [PATCH 12/13] x86/mm: calculate_table_space_size based on memory ranges that are being mapped Yinghai Lu
2012-09-30 7:57 ` [PATCH 13/13] x86, mm: Use func pointer to table size calculation and mapping Yinghai Lu
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1348991844-12285-7-git-send-email-yinghai@kernel.org \
--to=yinghai@kernel.org \
--cc=hpa@zytor.com \
--cc=jacob.shin@amd.com \
--cc=linux-kernel@vger.kernel.org \
--cc=mingo@elte.hu \
--cc=tglx@linutronix.de \
--cc=tj@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).