linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: "Henrik Nordström" <henrik@henriknordstrom.net>
To: linux-sunxi@googlegroups.com
Cc: dev@linux-sunxi.org,
	Maxime Ripard <maxime.ripard@free-electrons.com>,
	David Woodhouse <dwmw2@infradead.org>,
	linux-mtd@lists.infradead.org,
	"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>
Subject: Re: [linux-sunxi] Re: [RFC PATCH 0/9] mtd: nand: add sunxi NAND Flash Controller support
Date: Tue, 21 Jan 2014 21:55:34 +0100	[thread overview]
Message-ID: <1390337734.5046.24.camel@localhost> (raw)
In-Reply-To: <1390328011.5046.16.camel@localhost>

tis 2014-01-21 klockan 19:13 +0100 skrev Henrik Nordström:
> > Are you sure ?
> > This thread says that only the first 1024 bytes of data (+ 96 bytes of
> > ECC) of each page are used:
> 
> yes I am sure. There was no page access commands between the sectors,
> only linear read of data,ecc,data,ecc.

Hmm.. but thinking back I am no longer so sure. Need to test this again
while verifying with logic probe what is going on.

Regards
Henrik


  reply	other threads:[~2014-01-21 20:56 UTC|newest]

Thread overview: 40+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2014-01-08 14:21 [RFC PATCH 0/9] mtd: nand: add sunxi NAND Flash Controller support Boris BREZILLON
     [not found] ` < 1389190924-26226-4-git-send-email-b.brezillon@overkiz.com>
2014-01-08 14:21 ` [RFC PATCH 1/9] mtd: nand: retrieve ECC requirements from Hynix READ ID byte 4 Boris BREZILLON
2014-01-23  1:49   ` Brian Norris
2014-01-29 10:29     ` boris brezillon
2014-02-05 13:53     ` Boris BREZILLON
2014-01-08 14:21 ` [RFC PATCH 2/9] mtd: nand: define struct nand_timings Boris BREZILLON
2014-01-08 14:21 ` [RFC PATCH 3/9] of: mtd: add NAND timings retrieval support Boris BREZILLON
2014-01-08 16:30   ` Rob Herring
2014-01-08 16:36     ` boris brezillon
2014-01-08 18:34   ` Jason Gunthorpe
2014-01-08 19:00     ` boris brezillon
2014-01-08 19:13       ` Jason Gunthorpe
2014-01-09  8:36         ` boris brezillon
2014-01-09 17:35           ` Jason Gunthorpe
2014-01-15 15:09             ` boris brezillon
2014-01-15 17:03               ` boris brezillon
2014-01-21 22:57                 ` Jason Gunthorpe
2014-02-04 17:02                   ` Grant Likely
2014-01-08 14:21 ` [RFC PATCH 4/9] of: mtd: add NAND timings bindings documentation Boris BREZILLON
2014-01-08 14:22 ` [RFC PATCH 5/9] mtd: nand: add sunxi NFC support Boris BREZILLON
2014-01-08 19:21   ` boris brezillon
2014-01-08 14:22 ` [RFC PATCH 6/9] mtd: nand: add sunxi NFC dt bindings doc Boris BREZILLON
2014-01-08 21:28   ` Arnd Bergmann
2014-01-09  8:31     ` boris brezillon
2014-01-09 10:00       ` Arnd Bergmann
2014-01-08 14:22 ` [RFC PATCH 7/9] ARM: dt/sunxi: add NFC node to Allwinner A20 SoC Boris BREZILLON
2014-01-08 14:22 ` [RFC PATCH 8/9] ARM: dt/sunxi: add NFC pinctrl pin definitions Boris BREZILLON
2014-01-08 15:28 ` [RFC PATCH 9/9] ARM: sunxi/dt: enable NAND on cubietruck board Boris BREZILLON
2014-01-08 15:30   ` boris brezillon
2014-01-11 13:38 ` [RFC PATCH 0/9] mtd: nand: add sunxi NAND Flash Controller support boris brezillon
     [not found]   ` <1389449230.19197.2.camel@localhost>
     [not found]     ` <52D1541F.4040400@overkiz.com>
     [not found]       ` <1389456075.20989.11.camel@localhost>
     [not found]         ` <1389474709.22660.4.camel@localhost>
2014-01-13  9:02           ` [linux-sunxi] " boris brezillon
2014-01-13  9:48             ` Henrik Nordström
     [not found]               ` <6de6ead1-e437-410b-91c0-74afb37dbf39@googlegroups.com>
2014-01-21 18:13                 ` Henrik Nordström
2014-01-21 20:55                   ` Henrik Nordström [this message]
2014-01-29 15:11             ` Michal Suchanek
2014-01-29 15:43               ` boris brezillon dev
2014-01-29 16:08                 ` Michal Suchanek
2014-01-29 16:55                   ` boris brezillon dev
2014-01-23 15:22   ` Rob Herring
2014-01-29 10:20     ` boris brezillon

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1390337734.5046.24.camel@localhost \
    --to=henrik@henriknordstrom.net \
    --cc=dev@linux-sunxi.org \
    --cc=dwmw2@infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-sunxi@googlegroups.com \
    --cc=maxime.ripard@free-electrons.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).