[RESEND PATCH v3 07/10] regulator: arizona-ldo1: Add additional supported voltage

[Charles Keepax <ckeepax@opensource.wolfsonmicro.com>]

This patch adds support for the 1.175V mode on the LDO1 regulator on the
wm5110. This is need as part of the low power sleep mode operation.

Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
Acked-by: Mark Brown <broonie@kernel.org>
---
 drivers/regulator/arizona-ldo1.c |   15 +++++++++++++++
 1 files changed, 15 insertions(+), 0 deletions(-)

diff --git a/drivers/regulator/arizona-ldo1.c b/drivers/regulator/arizona-ldo1.c
index a1d07d3..9094163 100644
--- a/drivers/regulator/arizona-ldo1.c
+++ b/drivers/regulator/arizona-ldo1.c
@@ -178,6 +178,16 @@ static const struct regulator_init_data arizona_ldo1_default = {
 	.num_consumer_supplies = 1,
 };
 
+static const struct regulator_init_data arizona_ldo1_wm5110 = {
+	.constraints = {
+		.min_uV = 1175000,
+		.max_uV = 1200000,
+		.valid_ops_mask = REGULATOR_CHANGE_STATUS |
+				  REGULATOR_CHANGE_VOLTAGE,
+	},
+	.num_consumer_supplies = 1,
+};
+
 static int arizona_ldo1_of_get_pdata(struct arizona *arizona,
 				     struct regulator_config *config,
 				     const struct regulator_desc *desc)
@@ -243,6 +253,11 @@ static int arizona_ldo1_probe(struct platform_device *pdev)
 		desc = &arizona_ldo1_hc;
 		ldo1->init_data = arizona_ldo1_dvfs;
 		break;
+	case WM5110:
+	case WM8280:
+		desc = &arizona_ldo1;
+		ldo1->init_data = arizona_ldo1_wm5110;
+		break;
 	default:
 		desc = &arizona_ldo1;
 		ldo1->init_data = arizona_ldo1_default;
-- 
1.7.2.5