Re: [PATCH v3 6/7] mfd: arizona: Update DT doc for new mic detection bindings

Lee Jones
2015-06-24T14:15:47Z

This requires a DT Ack.

[... which would be pretty difficult, as you didn't Cc them]

> Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
> ---
> Documentation/devicetree/bindings/mfd/arizona.txt | 16 ++++++++++++++++
> 1 files changed, 16 insertions(+), 0 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
> index 32a71b7..8d92c92 100644
> --- a/Documentation/devicetree/bindings/mfd/arizona.txt
> +++ b/Documentation/devicetree/bindings/mfd/arizona.txt
> @@ -68,6 +68,22 @@ Optional properties:
> If this node is not mentioned or if the value is unknown, then
> headphone detection mode is set to HPDETL.
>
> + - wlf,micd-detect-debounce : Additional software microphone detection
> + debounce specified in milliseconds.
> + - wlf,micd-pol-gpio : GPIO specifier for the GPIO controlling the headset
> + polarity if one exists.
> + - wlf,micd-bias-start-time : Time allowed for MICBIAS to startup prior to
> + performing microphone detection, specified as per the ARIZONA_MICD_TIME_XXX
> + defines.
> + - wlf,micd-rate : Delay between successive microphone detection measurements,
> + specified as per the ARIZONA_MICD_TIME_XXX defines.
> + - wlf,micd-dbtime : Microphone detection hardware debounces specified as the
> + number of measurements to take, valid values being 2 and 4.
> + - wlf,micd-timeout : Timeout for microphone detection, specified in
> + milliseconds.
> + - wlf,micd-force-micbias : Force MICBIAS continuously on during microphone
> + detection.
> +
> - DCVDD-supply, MICVDD-supply : Power supplies, only need to be specified if
> they are being externally supplied. As covered in
> Documentation/devicetree/bindings/regulator/regulator.txt

--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog