[PATCH v3 0/2] Add Cygnus PCIe Serdes/PHY support

[Ray Jui <rjui@broadcom.com>]

This patch series adds support for the Cygnus PCIe PHY

This patch series is based on Linux v4.3-rc1 and is avaliable in:
https://github.com/Broadcom/cygnus-linux/tree/cygnus-pcie-phy-v3

Changes from v2:
 - Dropped MDC/MDIO bus driver since it's not needed to enable/disable the
   analog-front-end of the PCIe Serdes on Cygnus
 - Optimized delay waiting for PCIe analog-front-end to be fully enabled
 - Reduce the #phy-cell to 1 since now the MDIO PHY ID is not required

Changes from v1:
 - Move the MDC/MDIO bus driver from drivers/phy/* to drivers/bus/*
 - Make the PCIe PHY device node child node of the MDIO bus
 - Change the PCIe PHY driver to tristate so it can be compiled as a module
 - Other minor changes

Ray Jui (2):
  dt-bindings: Add Broadcom Cygnus PCIe PHY binding
  phy: cygnus: pcie: Add Cygnus PCIe PHY support

 .../bindings/phy/brcm,cygnus-pcie-phy.txt          |  30 ++++
 drivers/phy/Kconfig                                |   9 +
 drivers/phy/Makefile                               |   1 +
 drivers/phy/phy-bcm-cygnus-pcie.c                  | 198 +++++++++++++++++++++
 4 files changed, 238 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/brcm,cygnus-pcie-phy.txt
 create mode 100644 drivers/phy/phy-bcm-cygnus-pcie.c

-- 
1.9.1