[REPOST PATCH] ftrace: Calculate the correct dyn_ftrace number to report to the userspace

[Minfei Huang <mnfhuang@gmail.com>]

Now, ftrace only calculate the dyn_ftrace number in the adding
breakpoint loop, not in adding update and finish update loop.

Calculate the correct dyn_ftrace, once ftrace reports the failure message
to the userspace.

Signed-off-by: Minfei Huang <mnfhuang@gmail.com>
---
 arch/x86/kernel/ftrace.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/x86/kernel/ftrace.c b/arch/x86/kernel/ftrace.c
index 8b7b0a5..311bcf3 100644
--- a/arch/x86/kernel/ftrace.c
+++ b/arch/x86/kernel/ftrace.c
@@ -556,6 +556,7 @@ void ftrace_replace_code(int enable)
 	run_sync();
 
 	report = "updating code";
+	count = 0;
 
 	for_ftrace_rec_iter(iter) {
 		rec = ftrace_rec_iter_record(iter);
@@ -563,11 +564,13 @@ void ftrace_replace_code(int enable)
 		ret = add_update(rec, enable);
 		if (ret)
 			goto remove_breakpoints;
+		count++;
 	}
 
 	run_sync();
 
 	report = "removing breakpoints";
+	count = 0;
 
 	for_ftrace_rec_iter(iter) {
 		rec = ftrace_rec_iter_record(iter);
@@ -575,6 +578,7 @@ void ftrace_replace_code(int enable)
 		ret = finish_update(rec, enable);
 		if (ret)
 			goto remove_breakpoints;
+		count++;
 	}
 
 	run_sync();
-- 
2.4.0