[PATCH v4 2/2] usb: musb: Fix DMA desired mode for Mentor DMA engine

[PATCH v4 2/2] usb: musb: Fix DMA desired mode for Mentor DMA engine

[Joshua Henderson]

From: Cristian Birsan <cristian.birsan@microchip.com>

Commit 754fe4a92c07 ("usb: musb: Remove ifdefs for TX DMA for musb_host.c")
introduces a problem setting the desired channel mode for the Mentor DMA
engine.

There is a case where an address is incorrectly assigned to the DMA
channel desired mode when it should instead be assigned the actual mode
value. This results in the value of channel->desired_mode not being
correct.

Signed-off-by: Cristian Birsan <cristian.birsan@microchip.com>
Signed-off-by: Joshua Henderson <joshua.henderson@microchip.com>
Tested-by: Ladislav Michl <ladis@linux-mips.org>
Acked-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
---
Changes since v3: None
Changes since v2:
	- Fix wording in commit message.
Changes since v1:
	- Fix commit comment citing the cause of the regression.
---
 drivers/usb/musb/musb_host.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/usb/musb/musb_host.c b/drivers/usb/musb/musb_host.c
index 75c89b4..58487a4 100644
--- a/drivers/usb/musb/musb_host.c
+++ b/drivers/usb/musb/musb_host.c
@@ -662,7 +662,7 @@ static int musb_tx_dma_set_mode_mentor(struct dma_controller *dma,
 		csr &= ~(MUSB_TXCSR_AUTOSET | MUSB_TXCSR_DMAMODE);
 		csr |= MUSB_TXCSR_DMAENAB; /* against programmer's guide */
 	}
-	channel->desired_mode = mode;
+	channel->desired_mode = *mode;
 	musb_writew(epio, MUSB_TXCSR, csr);
 
 	return 0;
-- 
1.7.9.5