[PATCH 06/15] net/fsl_pq_mdio: use IS_ENABLED() instead of checking for built-in or module

Javier Martinez Canillas
2016-09-12T14:04:43Z

drivers/net/ethernet/freescale/fsl_pq_mdio.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/freescale/fsl_pq_mdio.c b/drivers/net/ethernet/freescale/fsl_pq_mdio.c
index f3c63dce1e30..446c7b374ff5 100644
--- a/drivers/net/ethernet/freescale/fsl_pq_mdio.c
+++ b/drivers/net/ethernet/freescale/fsl_pq_mdio.c
@@ -195,7 +195,7 @@ static int fsl_pq_mdio_reset(struct mii_bus *bus)
return 0;
}

-#if defined(CONFIG_GIANFAR) || defined(CONFIG_GIANFAR_MODULE)
+#if IS_ENABLED(CONFIG_GIANFAR)
/*
* Return the TBIPA address, starting from the address
* of the mapped GFAR MDIO registers (struct gfar)
@@ -228,7 +228,7 @@ static uint32_t __iomem *get_etsec_tbipa(void __iomem *p)
}
#endif

-#if defined(CONFIG_UCC_GETH) || defined(CONFIG_UCC_GETH_MODULE)
+#if IS_ENABLED(CONFIG_UCC_GETH)
/*
* Return the TBIPAR address for a QE MDIO node, starting from the address
* of the mapped MII registers (struct fsl_pq_mii)
@@ -306,7 +306,7 @@ static void ucc_configure(phys_addr_t start, phys_addr_t end)
#endif

static const struct of_device_id fsl_pq_mdio_match[] = {
-#if defined(CONFIG_GIANFAR) || defined(CONFIG_GIANFAR_MODULE)
+#if IS_ENABLED(CONFIG_GIANFAR)
{
.compatible = "fsl,gianfar-tbi",
.data = &(struct fsl_pq_mdio_data) {
@@ -344,7 +344,7 @@ static const struct of_device_id fsl_pq_mdio_match[] = {
},
},
#endif
-#if defined(CONFIG_UCC_GETH) || defined(CONFIG_UCC_GETH_MODULE)
+#if IS_ENABLED(CONFIG_UCC_GETH)
{
.compatible = "fsl,ucc-mdio",
.data = &(struct fsl_pq_mdio_data) {
--
2.7.4