[PATCH 24/51] extcon: gpio: Remove the usage of extcon_set_state()

Kishon Vijay Abraham I
2016-09-14T07:45:24Z

From: Chanwoo Choi <cw00.choi@samsung.com>

This patch removes the usage of extcon_set_state() because it uses
the bit masking to change the state of external connectors. The extcon framework
should handle the state by extcon_set_cable_state_() with extcon id.

Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
---
drivers/extcon/extcon-gpio.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/extcon/extcon-gpio.c b/drivers/extcon/extcon-gpio.c
index d023789..b1b0264 100644
--- a/drivers/extcon/extcon-gpio.c
+++ b/drivers/extcon/extcon-gpio.c
@@ -49,7 +49,7 @@ static void gpio_extcon_work(struct work_struct *work)
state = gpiod_get_value_cansleep(data->id_gpiod);
if (data->pdata->gpio_active_low)
state = !state;
- extcon_set_state(data->edev, state);
+ extcon_set_cable_state_(data->edev, data->pdata->extcon_id, state);
}

static irqreturn_t gpio_irq_handler(int irq, void *dev_id)
--
1.7.9.5