[PATCH 2/2] arm64: marvell: dts: add second 1G port on the Armada 8040 DB

[Marcin Wojtas <mw@semihalf.com>]

Armada 8040 DB is equipped with 4 (2x 10G SFI + 2x 1G RGMII)
ethernet ports of which only one was hitherto enabled.
Because currently mvpp2 driver is capable of supporting only
1G RGMII/SGMII, enable second port from CP slave HW block.

Signed-off-by: Marcin Wojtas <mw@semihalf.com>
---
 arch/arm64/boot/dts/marvell/armada-8040-db.dts | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
index dc0d084..3cde649 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
@@ -169,6 +169,22 @@
 	status = "okay";
 };
 
+&cps_mdio {
+	phy0: ethernet-phy@0 {
+		reg = <0>;
+	};
+};
+
+&cps_ethernet {
+	status = "okay";
+};
+
+&cps_eth1 {
+	status = "okay";
+	phy = <&phy0>;
+	phy-mode = "rgmii-id";
+};
+
 &ap_sdhci0 {
 	status = "okay";
 	bus-width = <4>;
-- 
1.8.3.1