Re: [PATCH 1/2] wcn36xx: Pass used skb to ieee80211_tx_status()

Bjorn Andersson
2017-05-18T05:05:44Z

On Wed 17 May 06:14 PDT 2017, Johannes Berg wrote:

> On Thu, 2017-05-04 at 13:13 +0000, Kalle Valo wrote:
> >
> > > > This code intentionally checked if TX status was requested, and
> > > > if not then it doesn't go to the effort of building it.
> > > >
> > >
> > > What I'm finding puzzling is the fact that the only caller of
> > > ieee80211_led_tx() is ieee80211_tx_status() and it seems like
> > > drivers, such as ath10k, call this for each packet handled - but
> > > I'm likely missing something.
>
> Yes, many drivers do call it for each packet, and as such, this
> deficiency was never noted.
>
> > > > As it is with your patch, it'll go and report the TX status
> > > > without any
> > > > TX status information - which is handled in
> > > > wcn36xx_dxe_tx_ack_ind()
> > > > for those frames needing it.
> > > >
> > >
> > > Right, it doesn't sound desired. However, during normal operation
> > > I'm not seeing IEEE80211_TX_CTL_REQ_TX_STATUS being set and as such
> > > ieee80211_led_tx() is never called.
> >
> > So what's the conclusion? How do we get leds working?
>
> Well, frankly, I never thought the TX LED was a super good idea - but
> it had been supported by the original code IIRC, so never removed. Some
> people like frantic blinking I guess ;-)
>

It seems very important to a lot of people...

But if ieee80211_free_txskb() is the counterpart of
ieee80211_tx_status() then we should be able to push the
ieee80211_led_tx() call down into ieee80211_report_used_skb() and handle
both cases.

The ieee80211_free_txskb() seems to be used in various cases where we
discard skbs, but perhaps this is not an issue in reality.

> But I think the problem also applies to the throughput trigger thing,
> so perhaps we need to stick some LED feedback calls into other places,
> like _noskb() or provide an extra way to do it?
>

Looking around it seems that we either have a call to free_txskb() or
one of the tx_status(); where the _noskb() would need some special
handling. Are there others or would it be reasonable to add a call in
this one "special" case?

Regards,
Bjorn