[PATCH 1/2] dt-bindings: net: Add bindings for National Instruments XGE netdev

[Moritz Fischer <mdf@kernel.org>]

This adds bindings for the NI XGE 1G/10G network device.

Signed-off-by: Moritz Fischer <mdf@kernel.org>
---
 Documentation/devicetree/bindings/net/nixge.c | 32 +++++++++++++++++++++++++++
 1 file changed, 32 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/nixge.c

diff --git a/Documentation/devicetree/bindings/net/nixge.c b/Documentation/devicetree/bindings/net/nixge.c
new file mode 100644
index 0000000..9fff5a7
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/nixge.c
@@ -0,0 +1,32 @@
+* NI XGE Ethernet controller
+
+Required properties:
+- compatible: Should be "ni,xge-enet-2.00"
+- reg: Address and length of the register set for the device
+- interrupts: Should contain tx and rx interrupt
+- interrupt-names: Should be "rx-irq" and "tx-irq"
+- phy-mode: See ethernet.txt file in the same directory.
+- nvmem-cells: Phandle of nvmem cell containing the mac address
+- nvmem-cell-names: Should be "address"
+
+Examples (10G generic PHY):
+	nixge0: ethernet@40000000 {
+		compatible = "ni,xge-enet-2.00";
+		reg = <0x40000000 0x6000>;
+
+		nvmem-cells = <&eth1_addr>;
+		nvmem-cell-names = "address";
+
+		interrupts = <0 29 4>, <0 30 4>;
+		interrupt-names = "rx-irq", "tx-irq";
+		interrupt-parent = <&intc>;
+
+		phy-mode = "xgmii";
+		phy-handle = <&ethernet_phy1>;
+
+		ethernet_phy1: ethernet-phy@4 {
+			compatible = "ethernet-phy-ieee802.3-c45";
+			reg = <4>;
+			devices = <0xa>;
+		};
+	};
-- 
2.7.4