Problems playing audio cds with ide-scsi installed.

Problems playing audio cds with ide-scsi installed.

[Rick Hayner]

Hello to all.

I have the following setup.
tyan s1590s motherboard, 64mb ram, two ide ports on board, amdk63d
processor.

I am running debian linux using kernel 2.2.19.

I have a Ricoh MP7120 cdrw drive.  This is an atapi drive.  Because of
this I need to use the ide-scsi driver along with the sg driver.

I have no trouble at all writing audio or data cds using cdrecord.
The  problem comes when I need to play an audio cd.  If I have just
put the cd in the drive, any audio cd player works fine.  However
after a stop command with either cdcd or cdtool, I must issue two cdcd
play commands in a row, or two cdplay commands in the case of cdtool
in order to get the cd to begin playing again.  

The cdrw drive is on the secondary port and it is a master.

I have the following append command in lilo.conf
append="hdc=ide-scsi"
If I remove  this command, and make /dev/cdrom point to /dev/hdc, the
problem disappears altogether.  I've looked in every log file I can
find on the system and cannot find any error messages anywhere.  The
audio cd players just don't do anything at all on the first play
command after a stop command.  I've read the ide documentation, and
there is very little said about ide-scsi.

Does anyone have any idea as to what on earth is happening here?

Thanks for any help.

Sincerely, 
-- 
Rick Hayner
rhayner@complink.net
Member spebsqsa, Baritone Kalamazoo Mall City Chorus.
Amateur radio station wa8jqv