[PATCH v1 3/8] bus: mhi: core: Read transfer length from an event properly

[Bhaumik Bhatt <bbhatt@codeaurora.org>]

From: Hemant Kumar <hemantk@codeaurora.org>

When MHI Driver receives an EOT event, it reads xfer_len from the
event in the last TRE. The value is under control of the MHI device
and never validated by Host MHI driver. The value should never be
larger than the real size of the buffer but a malicious device can
set the value 0xFFFF as maximum. This causes device to memory
overflow (both read or write). Fix this issue by reading minimum of
transfer length from event and the buffer length provided.

Signed-off-by: Hemant Kumar <hemantk@codeaurora.org>
---
 drivers/bus/mhi/core/main.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/bus/mhi/core/main.c b/drivers/bus/mhi/core/main.c
index ba8afa7..3802d3b 100644
--- a/drivers/bus/mhi/core/main.c
+++ b/drivers/bus/mhi/core/main.c
@@ -521,7 +521,8 @@ static int parse_xfer_event(struct mhi_controller *mhi_cntrl,
 				mhi_cntrl->unmap_single(mhi_cntrl, buf_info);
 
 			result.buf_addr = buf_info->cb_buf;
-			result.bytes_xferd = xfer_len;
+			result.bytes_xferd =
+				min_t(u16, xfer_len, buf_info->len);
 			mhi_del_ring_element(mhi_cntrl, buf_ring);
 			mhi_del_ring_element(mhi_cntrl, tre_ring);
 			local_rp = tre_ring->rp;
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project