[PATCH v6 1/2] scsi: ufs: Fix ufs clk specs violation

[PATCH v6 1/2] scsi: ufs: Fix ufs clk specs violation

[Ziqi Chen]

As per specs, e.g, JESD220E chapter 7.2, while powering
off/on the ufs device, REF_CLK signal should be between
VSS(Ground) and VCCQ/VCCQ2.

Reviewed-by: Can Guo <cang@codeaurora.org>
Signed-off-by: Ziqi Chen <ziqichen@codeaurora.org>
---
 drivers/scsi/ufs/ufshcd.c | 20 ++++++++++----------
 1 file changed, 10 insertions(+), 10 deletions(-)

diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index e221add..3f807f7 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -8686,8 +8686,6 @@ static int ufshcd_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 	if (ret)
 		goto set_dev_active;
 
-	ufshcd_vreg_set_lpm(hba);
-
 disable_clks:
 	/*
 	 * Call vendor specific suspend callback. As these callbacks may access
@@ -8711,6 +8709,8 @@ static int ufshcd_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 					hba->clk_gating.state);
 	}
 
+	ufshcd_vreg_set_lpm(hba);
+
 	/* Put the host controller in low power mode if possible */
 	ufshcd_hba_vreg_set_lpm(hba);
 	goto out;
@@ -8778,18 +8778,18 @@ static int ufshcd_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 	old_link_state = hba->uic_link_state;
 
 	ufshcd_hba_vreg_set_hpm(hba);
+	ret = ufshcd_vreg_set_hpm(hba);
+	if (ret)
+		goto out;
+
 	/* Make sure clocks are enabled before accessing controller */
 	ret = ufshcd_setup_clocks(hba, true);
 	if (ret)
-		goto out;
+		goto disable_vreg;
 
 	/* enable the host irq as host controller would be active soon */
 	ufshcd_enable_irq(hba);
 
-	ret = ufshcd_vreg_set_hpm(hba);
-	if (ret)
-		goto disable_irq_and_vops_clks;
-
 	/*
 	 * Call vendor specific resume callback. As these callbacks may access
 	 * vendor specific host controller register space call them when the
@@ -8797,7 +8797,7 @@ static int ufshcd_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 	 */
 	ret = ufshcd_vops_resume(hba, pm_op);
 	if (ret)
-		goto disable_vreg;
+		goto disable_irq_and_vops_clks;
 
 	/* For DeepSleep, the only supported option is to have the link off */
 	WARN_ON(ufshcd_is_ufs_dev_deepsleep(hba) && !ufshcd_is_link_off(hba));
@@ -8864,8 +8864,6 @@ static int ufshcd_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 	ufshcd_link_state_transition(hba, old_link_state, 0);
 vendor_suspend:
 	ufshcd_vops_suspend(hba, pm_op);
-disable_vreg:
-	ufshcd_vreg_set_lpm(hba);
 disable_irq_and_vops_clks:
 	ufshcd_disable_irq(hba);
 	if (hba->clk_scaling.is_allowed)
@@ -8876,6 +8874,8 @@ static int ufshcd_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 		trace_ufshcd_clk_gating(dev_name(hba->dev),
 					hba->clk_gating.state);
 	}
+disable_vreg:
+	ufshcd_vreg_set_lpm(hba);
 out:
 	hba->pm_op_in_progress = 0;
 	if (ret)
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

RE: [PATCH v6 1/2] scsi: ufs: Fix ufs clk specs violation

[Avri Altman]

> 
> 
> As per specs, e.g, JESD220E chapter 7.2, while powering
> off/on the ufs device, REF_CLK signal should be between
> VSS(Ground) and VCCQ/VCCQ2.
> 
> Reviewed-by: Can Guo <cang@codeaurora.org>
> Signed-off-by: Ziqi Chen <ziqichen@codeaurora.org>
Aked-by: Avri Altman <avri.altman@wdc.com>

[PATCH v6 2/2] scsi: ufs-qcom: Fix ufs RST_n specs violation

[Ziqi Chen]

As per specs, e.g, JESD220E chapter 7.2, while powering
off/on the ufs device, RST_n signal should be between
VSS(Ground) and VCCQ/VCCQ2.

Signed-off-by: Ziqi Chen <ziqichen@codeaurora.org>
---
 drivers/scsi/ufs/ufs-qcom.c | 18 ++++++++++++++++--
 1 file changed, 16 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 2206b1e..f97d7b0 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -568,6 +568,17 @@ static int ufs_qcom_link_startup_notify(struct ufs_hba *hba,
 	return err;
 }
 
+static void ufs_qcom_device_reset_ctrl(struct ufs_hba *hba, bool asserted)
+{
+	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
+
+	/* reset gpio is optional */
+	if (!host->device_reset)
+		return;
+
+	gpiod_set_value_cansleep(host->device_reset, asserted);
+}
+
 static int ufs_qcom_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 {
 	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
@@ -582,6 +593,9 @@ static int ufs_qcom_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 		ufs_qcom_disable_lane_clks(host);
 		phy_power_off(phy);
 
+		/* reset the connected UFS device during power down */
+		ufs_qcom_device_reset_ctrl(hba, true);
+
 	} else if (!ufs_qcom_is_link_active(hba)) {
 		ufs_qcom_disable_lane_clks(host);
 	}
@@ -1421,10 +1435,10 @@ static int ufs_qcom_device_reset(struct ufs_hba *hba)
 	 * The UFS device shall detect reset pulses of 1us, sleep for 10us to
 	 * be on the safe side.
 	 */
-	gpiod_set_value_cansleep(host->device_reset, 1);
+	ufs_qcom_device_reset_ctrl(hba, true);
 	usleep_range(10, 15);
 
-	gpiod_set_value_cansleep(host->device_reset, 0);
+	ufs_qcom_device_reset_ctrl(hba, false);
 	usleep_range(10, 15);
 
 	return 0;
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

RE: [PATCH v6 2/2] scsi: ufs-qcom: Fix ufs RST_n specs violation

[Avri Altman]

> 
> 
> As per specs, e.g, JESD220E chapter 7.2, while powering
> off/on the ufs device, RST_n signal should be between
> VSS(Ground) and VCCQ/VCCQ2.
> 
> Signed-off-by: Ziqi Chen <ziqichen@codeaurora.org>
Aked-by: Avri Altman <avri.altman@wdc.com>