[PATCH v5] Add board support for HK10 board variants

Gokul Sriram Palanisamy
2021-02-26T08:31:16Z

Added support for HK10-C1 and HK10-C2 board variants based on IPQ8074 SoC.
Both these variants support dual QCN9000 PCIe cards that uses MHI communication
protocol over PCIe. In addition, HK10-C1 support on-chip radio.
Both these variants slightly differ in clock configuation for ethernet.

This series depends on below series:
[V2,0/7] Add PCIe support for IPQ8074
[v8,0/9] remoteproc: qcom: q6v5-wcss: Add support for secure pil

changes since v4:
- Addressed review comments.
- Addressing Kalle's comments, removed memory reservations in dts.
- Addressing Manivannan's comments, removed dts entry for mhi

changes since v3:
- Addressed build failure reported by test robot
in patch 3

changes since v2:
- In patch 3, Moved pcie0_rp and pcie1_rp nodes and
removed unused members and subnodes

Gokul Sriram Palanisamy (1):
arm64: dts: Add board support for HK10

arch/arm64/boot/dts/qcom/Makefile | 2 +
arch/arm64/boot/dts/qcom/ipq8074-hk10-c1.dts | 11 ++++
arch/arm64/boot/dts/qcom/ipq8074-hk10-c2.dts | 14 +++++
arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi | 76 ++++++++++++++++++++++++++++
4 files changed, 103 insertions(+)
create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10-c1.dts
create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10-c2.dts
create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi

--
2.7.4