[PATCH net-next 4/6] net: pci200syn: add some required spaces

Peng Li
2021-06-15T13:58:00Z

Add spaces required after that close brace '}'.
Add spaces required before the open parenthesis '('.
Add spaces required after that ','.

Signed-off-by: Peng Li <lipeng321@huawei.com>
---
drivers/net/wan/pci200syn.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)

diff --git a/drivers/net/wan/pci200syn.c b/drivers/net/wan/pci200syn.c
index cee3d65..ac4a599 100644
--- a/drivers/net/wan/pci200syn.c
+++ b/drivers/net/wan/pci200syn.c
@@ -56,7 +56,7 @@ typedef struct {
u32 cs_base[4]; /* 3C-48h : Chip Select Base Addrs */
u32 intr_ctrl_stat; /* 4Ch : Interrupt Control/Status */
u32 init_ctrl; /* 50h : EEPROM ctrl, Init Ctrl, etc */
-}plx9052;
+} plx9052;

typedef struct port_s {
struct napi_struct napi;
@@ -72,7 +72,7 @@ typedef struct port_s {
u16 txlast;
u8 rxs, txs, tmc; /* SCA registers */
u8 chan; /* physical port # - 0 or 1 */
-}port_t;
+} port_t;

typedef struct card_s {
u8 __iomem *rambase; /* buffer memory base (virtual) */
@@ -84,7 +84,7 @@ typedef struct card_s {
u8 irq; /* interrupt request level */

port_t ports[2];
-}card_t;
+} card_t;

#define get_port(card, port) (&card->ports[port])
#define sca_flush(card) (sca_in(IER0, card))
@@ -117,7 +117,7 @@ static void pci200_set_iface(port_t *port)

sca_out(EXS_TES1, (port->chan ? MSCI1_OFFSET : MSCI0_OFFSET) + EXS,
port->card);
- switch(port->settings.clock_type) {
+ switch (port->settings.clock_type) {
case CLOCK_INT:
rxs |= CLK_BRG; /* BRG output */
txs |= CLK_PIN_OUT | CLK_TX_RXCLK; /* RX clock */
@@ -184,7 +184,7 @@ static int pci200_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd)
if (cmd != SIOCWANDEV)
return hdlc_ioctl(dev, ifr, cmd);

- switch(ifr->ifr_settings.type) {
+ switch (ifr->ifr_settings.type) {
case IF_GET_IFACE:
ifr->ifr_settings.type = IF_IFACE_V35;
if (ifr->ifr_settings.size < size) {
@@ -301,13 +301,13 @@ static int pci200_pci_init_one(struct pci_dev *pdev,
return -EFAULT;
}

- plxphys = pci_resource_start(pdev,0) & PCI_BASE_ADDRESS_MEM_MASK;
+ plxphys = pci_resource_start(pdev, 0) & PCI_BASE_ADDRESS_MEM_MASK;
card->plxbase = ioremap(plxphys, PCI200SYN_PLX_SIZE);

- scaphys = pci_resource_start(pdev,2) & PCI_BASE_ADDRESS_MEM_MASK;
+ scaphys = pci_resource_start(pdev, 2) & PCI_BASE_ADDRESS_MEM_MASK;
card->scabase = ioremap(scaphys, PCI200SYN_SCA_SIZE);

- ramphys = pci_resource_start(pdev,3) & PCI_BASE_ADDRESS_MEM_MASK;
+ ramphys = pci_resource_start(pdev, 3) & PCI_BASE_ADDRESS_MEM_MASK;
card->rambase = pci_ioremap_bar(pdev, 3);

if (!card->plxbase || !card->scabase || !card->rambase) {
--
2.8.1