Re: [PATCH v3 1/5] powerpc/interrupt: Rename and lightly change syscall_exit_prepare_main()

[Nicholas Piggin <npiggin@gmail.com>]

Excerpts from Christophe Leroy's message of June 15, 2021 6:33 pm:
> Rename syscall_exit_prepare_main() into interrupt_exit_prepare_main()
> 
> Make it static as it is not used anywhere else.
> 
> Pass it the 'ret' so that it can 'or' it directly instead of
> oring twice, once inside the function and once outside.
> 
> And remove 'r3' parameter which is not used.
> 
> Also fix a typo where CONFIG_PPC_BOOK3S should be CONFIG_PPC_BOOK3S_64.
> 
> Signed-off-by: Christophe Leroy <christophe.leroy@csgroup.eu>
> Reviewed-by: Nicholas Piggin <npiggin@gmail.com>
> ---
> This series applies on top of Nic's series speeding up interrupt return on 64s
> 
>  arch/powerpc/kernel/interrupt.c | 11 +++++------
>  1 file changed, 5 insertions(+), 6 deletions(-)
> 
> diff --git a/arch/powerpc/kernel/interrupt.c b/arch/powerpc/kernel/interrupt.c
> index 74c995a42399..ba2d602d2da6 100644
> --- a/arch/powerpc/kernel/interrupt.c
> +++ b/arch/powerpc/kernel/interrupt.c
> @@ -243,11 +243,10 @@ static notrace void booke_load_dbcr0(void)
>  #endif
>  }
>  
> -notrace unsigned long syscall_exit_prepare_main(unsigned long r3,
> -						struct pt_regs *regs)
> +static notrace unsigned long
> +interrupt_exit_user_prepare_main(struct pt_regs *regs, unsigned long ret)

Hmm, I tried switching the order of the arguments thinking it would 
match caller and return registers better but didn't seem to help
generated code. Yet I think I will make that change to your patch if
you don't mind.

Thanks,
Nick