[PATCH 8/8] scsi: libsas: Decode SAM status and host byte codes

[John Garry <john.garry@huawei.com>]

Value 0 is used for SAM status and libsas exec_status bytes codes in
sas_end_task() - use defined macros instead. In addition, change to
proper enum types.

Also replace SAM_STAT_CHECK_CONDITION with SAS_SAM_STAT_CHECK_CONDITION,
the former being a proper member of enum exec_status.

Signed-off-by: John Garry <john.garry@huawei.com>
---
 drivers/scsi/libsas/sas_scsi_host.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/scsi/libsas/sas_scsi_host.c b/drivers/scsi/libsas/sas_scsi_host.c
index d337fdf1b9ca..fb19e739a39c 100644
--- a/drivers/scsi/libsas/sas_scsi_host.c
+++ b/drivers/scsi/libsas/sas_scsi_host.c
@@ -37,7 +37,8 @@
 static void sas_end_task(struct scsi_cmnd *sc, struct sas_task *task)
 {
 	struct task_status_struct *ts = &task->task_status;
-	int hs = 0, stat = 0;
+	enum scsi_host_status hs = DID_OK;
+	enum exec_status stat = SAS_SAM_STAT_GOOD;
 
 	if (ts->resp == SAS_TASK_UNDELIVERED) {
 		/* transport error */
@@ -82,10 +83,10 @@ static void sas_end_task(struct scsi_cmnd *sc, struct sas_task *task)
 		case SAS_ABORTED_TASK:
 			hs = DID_ABORT;
 			break;
-		case SAM_STAT_CHECK_CONDITION:
+		case SAS_SAM_STAT_CHECK_CONDITION:
 			memcpy(sc->sense_buffer, ts->buf,
 			       min(SCSI_SENSE_BUFFERSIZE, ts->buf_valid_size));
-			stat = SAM_STAT_CHECK_CONDITION;
+			stat = SAS_SAM_STAT_CHECK_CONDITION;
 			break;
 		default:
 			stat = ts->stat;
-- 
2.26.2