Re: [RFC] Early flush (was: spindown)

[Richard Gooch <rgooch@ras.ucalgary.ca>]

Daniel Phillips writes:
> On Wednesday 20 June 2001 06:39, Richard Gooch wrote:
> > Starting I/O immediately if there is no load sounds nice. However,
> > what about the other case, when the disc is already spun down (and
> > hence there's no I/O load either)? I want the system to avoid doing
> > writes while the disc is spun down. I'm quite happy for the system to
> > accumulate dirtied pages/buffers, reclaiming clean pages as needed,
> > until it absolutely has to start writing out (or I call sync(2)).
> 
> I'd like that too, but what about sync writes?  As things stand now,
> there is no option but to spin the disk back up.  To get around this
> we'd have to change the basic behavior of the block device and
> that's doable, but it's an entirely different proposition than the
> little patch above.

I don't care as much about sync writes. They don't seem to happen very
often on my boxes.

> You know about this project no doubt:
> 
>    http://noflushd.sourceforge.net/

Only vaguely. It's huge. Over 2300 lines of C code and >560 lines in
.h files! As you say, not really lightweight. There must be a better
way. Also, I suspect (without having looked at the code) that it
doesn't handle memory pressure well. Things may get nasty when we run
low on free pages.

				Regards,

					Richard....
Permanent: rgooch@atnf.csiro.au
Current:   rgooch@ras.ucalgary.ca