From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Tue, 11 Dec 2001 18:36:25 -0500 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Tue, 11 Dec 2001 18:36:14 -0500 Received: from think.faceprint.com ([166.90.149.11]:22421 "EHLO think.faceprint.com") by vger.kernel.org with ESMTP id ; Tue, 11 Dec 2001 18:35:31 -0500 Date: Tue, 11 Dec 2001 18:32:30 -0500 To: linux-kernel@vger.kernel.org Subject: /proc/stat not showing disk_io stats for all disks Message-ID: <20011211233230.GA1171@faceprint.com> Mime-Version: 1.0 Content-Type: multipart/signed; micalg=pgp-sha1; protocol="application/pgp-signature"; boundary="8t9RHnE3ZwKMSgU+" Content-Disposition: inline User-Agent: Mutt/1.3.24i From: faceprint@faceprint.com (Nathan Walp) Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org --8t9RHnE3ZwKMSgU+ Content-Type: text/plain; charset=us-ascii Content-Disposition: inline Content-Transfer-Encoding: quoted-printable I didn't notice this at first when I made the "jump" from the -ac series to the linus, and now to the marcelo kernels, but /proc/stat is only showing the disk_io statistics for my scsi drive. It is not showing the statistics for my IDE drive. 2.4.13-ac8: disk_io: (8,0):(708,669,11701,39,1688) (33,0):(21,17,120,4,32)=20 2.4.17-pre7 disk_io: (8,0):(6097,5247,103381,850,29624) I have one SCSI card (an adaptec 29160N) running with 1 scsi drive, and 2 cd-rom drives. ide0 and ide1 are not used, as they are the onboard (ATA/66) controllers on my motherboard. ide2 ande ide3 are on the Promise ATA/100 controller integrated into my motherboard (A7V). =20 I don't remember changing any CONFIG options that would cause this, but it is possible (2.4.13-ac8 seems like eons ago). Below is a piece of my dmesg output from 2.4.17-pre7, maybe that will have some clues that I didn't think to mention. Hope someone can help me out. Nathan dmesg output: Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=3D= xx VP_IDE: IDE controller on PCI bus 00 dev 21 PCI: Enabling device 00:04.1 (0000 -> 0001) VP_IDE: chipset revision 16 VP_IDE: not 100% native mode: will probe irqs later ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=3D= xx VP_IDE: VIA vt82c686a (rev 22) IDE UDMA66 controller on pci00:04.1 VP_IDE: neither IDE port enabled (BIOS) PDC20265: IDE controller on PCI bus 00 dev 88 PCI: Found IRQ 10 for device 00:11.0 PCI: Sharing IRQ 10 with 00:0b.0 PDC20265: chipset revision 2 PDC20265: not 100% native mode: will probe irqs later keyboard: Timeout - AT keyboard not present?(ed) keyboard: Timeout - AT keyboard not present?(f4) PDC20265: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode. ide2: BM-DMA at 0x6800-0x6807, BIOS settings: hde:DMA, hdf:pio ide3: BM-DMA at 0x6808-0x680f, BIOS settings: hdg:pio, hdh:pio hde: IBM-DTLA-307045, ATA DISK drive ide2 at 0x8000-0x8007,0x7802 on irq 10 hde: 90069840 sectors (46116 MB) w/1916KiB Cache, CHS=3D89355/16/63, UDMA(1= 00) Partition check: /dev/ide/host2/bus0/target0/lun0: [PTBL] [5606/255/63] p1 p2 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001) PCI: Enabling device 00:0b.0 (0014 -> 0017) PCI: Found IRQ 10 for device 00:0b.0 PCI: Sharing IRQ 10 with 00:11.0 eth0: ADMtek Comet rev 17 at 0xe0818000, 00:04:5A:45:1C:DD, IRQ 10. Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 439M agpgart: Detected Via Apollo Pro KT133 chipset agpgart: AGP aperture is 64M @ 0xe4000000 [drm] AGP 0.99 on VIA Apollo KT133 @ 0xe4000000 64MB [drm] Initialized radeon 1.1.1 20010405 on minor 0 SCSI subsystem driver Revision: 1.00 PCI: Found IRQ 14 for device 00:09.0 PCI: Sharing IRQ 14 with 00:04.2 PCI: Sharing IRQ 14 with 00:04.3 scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4 aic7892: Ultra160 Wide Channel A, SCSI Id=3D7, 32/253 SCBs Vendor: SEAGATE Model: ST318436LW Rev: 0005 Type: Direct-Access ANSI SCSI revision: 03 (scsi0:A:0): 160.000MB/s transfers (80.000MHz DT, offset 31, 16bit) Vendor: PIONEER Model: CD-ROM DR-U12X Rev: 1.06 Type: CD-ROM ANSI SCSI revision: 02 (scsi0:A:2): 10.000MB/s transfers (10.000MHz, offset 15) Vendor: HP Model: CD-Writer+ 9200 Rev: 1.0c Type: CD-ROM ANSI SCSI revision: 04 (scsi0:A:6): 10.000MB/s transfers (10.000MHz, offset 15) scsi0:A:0:0: Tagged Queuing enabled. Depth 253 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 35885168 512-byte hdwr sectors (18373 MB) /dev/scsi/host0/bus0/target0/lun0: p1 p2 p3 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 2, lun 0 Attached scsi CD-ROM sr1 at scsi0, channel 0, id 6, lun 0 sr0: scsi3-mmc drive: 12x/12x xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.12 sr1: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray --=20 Nathan Walp || faceprint@faceprint.com GPG Fingerprint: || http://faceprint.com/ 5509 6EF3 928B 2363 9B2B DA17 3E46 2CDC 492D DB7E --8t9RHnE3ZwKMSgU+ Content-Type: application/pgp-signature Content-Disposition: inline -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.6 (GNU/Linux) Comment: For info see http://www.gnupg.org iD8DBQE8FpeOPkYs3Ekt234RAqVuAJ49RYUxQs5D87hyhkYhLgaOrQAl0QCgzPkp kRb06ZNkV/SzRxaAWGz6NKY= =8IRE -----END PGP SIGNATURE----- --8t9RHnE3ZwKMSgU+--