Re: oops at boot with 2.5.7 and i810

[Mike Fedyk <mfedyk@matchmail.com>]

On Tue, Mar 19, 2002 at 06:09:29PM +0100, Martin Dalecki wrote:
> Luigi Genoni wrote:
> >HI,
> >
> >also with 2.5.7, as with 2.5.6, I have problems at boot.
> >I get the usual oops while initialising IDE.
> >
> >my ide controller is:
> >
> >00:1f.1 IDE interface: Intel Corporation 82801AA IDE (rev 02) (prog-if 80
> >[Master])
> >        Subsystem: Intel Corporation 82801AA IDE
> >        Flags: bus master, medium devsel, latency 0
> >        I/O ports at 2460 [size=16]
> >
> >unfortunatelly, I do not have even the time to write down oops message,
> >but eip is c0135068, but then I do not find a similar entry in system.map
> >
> >any hint
> 
> This device is behaving quite like the 440MX chipset
> I have myself I can't therefore the oops expect beeing caused
> by a trivial programming error in the actual ide driver.
> I don't see much pointer acces in piix.c code as well.
> 
> However you could eventually just try apply the following
> pseudo diff to piix.c and then try again:
> 
> - 
> { PCI_DEVICE_ID_INTEL_82801AA_1,	PIIX_UDMA_66  | PIIX_PINGPONG },
> + 
> { PCI_DEVICE_ID_INTEL_82801AA_1,	PIIX_UDMA_66 },
> 
> Replaceing PIIX_UDMA_33 with PIIX_UDMA_33 could be worth a try as well.
> 

replace what with what?