public inbox for linux-kernel@vger.kernel.org
 help / color / mirror / Atom feed
* Re: USB lockup in 2.4.18-pre8
  2002-05-14 16:05 USB lockup in 2.4.18-pre8 Stephan von Krawczynski
@ 2002-05-14 15:14 ` Greg KH
  2002-05-14 16:17 ` USB lockup in 2.4.18-pre8 <-- typo 2.4.19-pre8 Stephan von Krawczynski
  1 sibling, 0 replies; 3+ messages in thread
From: Greg KH @ 2002-05-14 15:14 UTC (permalink / raw)
  To: Stephan von Krawczynski; +Cc: linux-kernel

On Tue, May 14, 2002 at 06:05:26PM +0200, Stephan von Krawczynski wrote:
> Hello,
> 
> beginning with 2.4.18-pre7 I notice a complete system lockup using a SANDISK
> SDDR-05 compactflash USB adapter.
> I used the device in earlier kernel versions with the "UHCI Alternate Driver",
> but in 2.4.18-pre7 I experienced a complete system lockup when mounting the
> flash card. So I switched over to "UHCI (Intel ..." device, which worked ok in
> 2.4.18-pre7.
> Unfortunately starting with 2.4.18-pre8 I had to find out that now both
> UHCI-drivers produce the lockup. Since I did not find any hints in lkml from
> others I thought it might be worth dropping a note...
> 
> I am willing to try out whatever is necessary.

Can you try compiling the usb-storage driver with the "Debug messages"
option enabled?  Then send the log file and info to the usb-storage
author/maintainer and the linux-usb-devel mailing list?  That's a better
place for questions like this.

thanks,

greg k-h

^ permalink raw reply	[flat|nested] 3+ messages in thread

* USB lockup in 2.4.18-pre8
@ 2002-05-14 16:05 Stephan von Krawczynski
  2002-05-14 15:14 ` Greg KH
  2002-05-14 16:17 ` USB lockup in 2.4.18-pre8 <-- typo 2.4.19-pre8 Stephan von Krawczynski
  0 siblings, 2 replies; 3+ messages in thread
From: Stephan von Krawczynski @ 2002-05-14 16:05 UTC (permalink / raw)
  To: linux-kernel

Hello,

beginning with 2.4.18-pre7 I notice a complete system lockup using a SANDISK
SDDR-05 compactflash USB adapter.
I used the device in earlier kernel versions with the "UHCI Alternate Driver",
but in 2.4.18-pre7 I experienced a complete system lockup when mounting the
flash card. So I switched over to "UHCI (Intel ..." device, which worked ok in
2.4.18-pre7.
Unfortunately starting with 2.4.18-pre8 I had to find out that now both
UHCI-drivers produce the lockup. Since I did not find any hints in lkml from
others I thought it might be worth dropping a note...

I am willing to try out whatever is necessary.

Regards,
Stephan


some system infos:

00:04.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16)
00:04.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16)

May  3 13:40:44 admin kernel: usb.c: registered new driver usbdevfs
May  3 13:40:44 admin kernel: usb.c: registered new driver hub
May  3 13:40:44 admin kernel: usb-uhci.c: $Revision: 1.275 $ time 13:31:52 May  3 2002
May  3 13:40:44 admin kernel: usb-uhci.c: High bandwidth mode enabled
May  3 13:40:44 admin kernel: usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 5
May  3 13:40:44 admin kernel: usb-uhci.c: Detected 2 ports
May  3 13:40:44 admin kernel: usb.c: new USB bus registered, assigned bus number 1
May  3 13:40:44 admin kernel: hub.c: USB hub found
May  3 13:40:44 admin kernel: hub.c: 2 ports detected
May  3 13:40:44 admin kernel: usb-uhci.c: USB UHCI at I/O 0xd000, IRQ 5
May  3 13:40:44 admin kernel: usb-uhci.c: Detected 2 ports
May  3 13:40:44 admin kernel: usb.c: new USB bus registered, assigned bus number 2
May  3 13:40:44 admin kernel: hub.c: USB hub found
May  3 13:40:44 admin kernel: hub.c: 2 ports detected
May  3 13:40:44 admin kernel: usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
May  3 13:40:44 admin kernel: hub.c: USB new device connect on bus1/1, assigned device number 2
May  3 13:40:44 admin kernel: usb.c: USB device 2 (vend/prod 0x781/0x1) is not claimed by any active driver.
May  3 13:40:44 admin kernel: Initializing USB Mass Storage driver...
May  3 13:40:44 admin kernel: usb.c: registered new driver usb-storage
May  3 13:40:44 admin kernel: scsi3 : SCSI emulation for USB Mass Storage devices
May  3 13:40:44 admin kernel:   Vendor:           Model:                   Rev:  
May  3 13:40:44 admin kernel:   Type:   Direct-Access                      ANSI SCSI revision: 02
May  3 13:40:44 admin kernel: Attached scsi removable disk sdb at scsi3, channel 0, id 0, lun 0  
May  3 13:40:44 admin kernel: usb-uhci.c: interrupt, status 3, frame# 1433
May  3 13:40:44 admin kernel: Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
May  3 13:40:44 admin kernel: sdb : READ CAPACITY failed.
May  3 13:40:44 admin kernel: sdb : status = 1, message = 00, host = 0, driver = 08
May  3 13:40:44 admin kernel: Current sd00:00: sns = 70  2
May  3 13:40:44 admin kernel: ASC=3a ASCQ= 0
May  3 13:40:44 admin kernel: Raw sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x08 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00
May  3 13:40:44 admin kernel: sdb : block size assumed to be 512 bytes, disk size 1GB.  
May  3 13:40:44 admin kernel:  sdb: I/O error: dev 08:10, sector 0
May  3 13:40:44 admin kernel:  I/O error: dev 08:10, sector 0
May  3 13:40:44 admin kernel:  unable to read partition table
May  3 13:40:44 admin kernel: WARNING: USB Mass Storage data integrity not assured
May  3 13:40:44 admin kernel: USB Mass Storage device found at 2
May  3 13:40:44 admin kernel: USB Mass Storage support registered.



^ permalink raw reply	[flat|nested] 3+ messages in thread

* Re: USB lockup in 2.4.18-pre8 <-- typo 2.4.19-pre8
  2002-05-14 16:05 USB lockup in 2.4.18-pre8 Stephan von Krawczynski
  2002-05-14 15:14 ` Greg KH
@ 2002-05-14 16:17 ` Stephan von Krawczynski
  1 sibling, 0 replies; 3+ messages in thread
From: Stephan von Krawczynski @ 2002-05-14 16:17 UTC (permalink / raw)
  To: linux-kernel

sed "s/2.4.18/2.4.19/g"

^ permalink raw reply	[flat|nested] 3+ messages in thread

end of thread, other threads:[~2002-05-14 16:18 UTC | newest]

Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2002-05-14 16:05 USB lockup in 2.4.18-pre8 Stephan von Krawczynski
2002-05-14 15:14 ` Greg KH
2002-05-14 16:17 ` USB lockup in 2.4.18-pre8 <-- typo 2.4.19-pre8 Stephan von Krawczynski

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox