USB Problems with 2.4.19-pre10-ac2

Martin Knoblauch
2002-06-13T17:14:15Z

Hi,

on connecting an Olympus 2100UZ camera via USB for use with gphoto2
I get the following messages from the kernel:

usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 18:05:42 Jun 13 2002
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: USB UHCI at I/O 0xdc00, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
hub.c: USB new device connect on bus1/2, assigned device number 2
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=2 (error=-110)
hub.c: USB new device connect on bus1/2, assigned device number 3
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=3 (error=-110)

Suspicious are the "usb_control/bulk_msg: timeout" messages and the "not
accepting" stuff. Same happens with the uhci.o module. The camera works with
the 2.4.18-4GB kernel from SuSE8.0. So I suspect some problems with
2.4.19-pre10-ac2. Unfortunatelly I cannot build 2.4.19-pre10 alone, due to
compilation errors.

Any idea? System in question is based on the VIA KT333 chipset, with an
xp2100+ CPU.

# lspci -v
00:00.0 Host bridge: VIA Technologies, Inc. VT8367 [KT266]
Subsystem: VIA Technologies, Inc. VT8367 [KT266]
Flags: bus master, 66Mhz, medium devsel, latency 0
Memory at e0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 2.0
Capabilities: [c0] Power Management version 2

00:01.0 PCI bridge: VIA Technologies, Inc. VT8367 [KT266 AGP] (prog-if 00
[Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
Memory behind bridge: e4000000-e5ffffff
Prefetchable memory behind bridge: d0000000-dfffffff
Capabilities: [80] Power Management version 2

00:0c.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev
74)
Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management
NIC
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at d000 [size=128]
Memory at e7000000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [dc] Power Management version 2

00:11.0 ISA bridge: VIA Technologies, Inc.: Unknown device 3147
Subsystem: VIA Technologies, Inc.: Unknown device 3147
Flags: bus master, stepping, medium devsel, latency 0
Capabilities: [c0] Power Management version 2

00:11.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) (prog-if
8a [Master SecP PriP])
Subsystem: VIA Technologies, Inc. Bus Master IDE
Flags: bus master, medium devsel, latency 32
I/O ports at d400 [size=16]
Capabilities: [c0] Power Management version 2

00:11.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 23) (prog-if 00
[UHCI])
Subsystem: Unknown device 0925:1234
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at d800 [size=32]
Capabilities: [80] Power Management version 2

00:11.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 23) (prog-if 00
[UHCI])
Subsystem: Unknown device 0925:1234
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at dc00 [size=32]
Capabilities: [80] Power Management version 2

00:11.5 Multimedia audio controller: VIA Technologies, Inc. AC97 Audio
Controller (rev 40)
Subsystem: Realtek Semiconductor Co., Ltd.: Unknown device 4710
Flags: medium devsel, IRQ 5
I/O ports at e000 [size=256]
Capabilities: [c0] Power Management version 2

01:00.0 VGA compatible controller: nVidia Corporation: Unknown device 0171
(rev a3) (prog-if 00 [VGA])
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 11
Memory at e4000000 (32-bit, non-prefetchable) [size=16M]
Memory at d0000000 (32-bit, prefetchable) [size=128M]
Memory at d8000000 (32-bit, prefetchable) [size=512K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Capabilities: [44] AGP version 2.0

Thanks