* 2.4.19 hangs on partition table check
@ 2002-08-05 14:59 bd
2002-08-05 15:07 ` Tyler Longren
0 siblings, 1 reply; 2+ messages in thread
From: bd @ 2002-08-05 14:59 UTC (permalink / raw)
To: linux-kernel
Hi,
during boot the kernel hangs when it tries to check the partition table
of one hd, a 120GB Maxtor. The gemometry is detected right though and
there are no problems with the 2.4.18 kernel where i used the same
configuration as with the new kernel.
the host is a i586 on a gigabyte HX motherboard and i am running debian
testing with the latest packages.
this drive (hdg) is atached to a promise66 pci card on the second controler
(ide3) and is the only drive there. i have two other maxtors (60GB and
80GB) atached to the other controler (ide2). the partition table checks
for those work fine.
if you need any other information, please let me know.
by
bd
$ cat /usr/src/linux/.config | grep PDC
CONFIG_BLK_DEV_PDC202XX=y
CONFIG_PDC202XX_BURST=y
# CONFIG_PDC202XX_FORCE is not set
# CONFIG_BLK_DEV_ATARAID_PDC is not set
$ cat /proc/pci
Bus 0, device 8, function 0:
Unknown mass storage controller: Promise Technology, Inc. 20262 (rev 1).
IRQ 11.
Master Capable. Latency=32.
I/O at 0x6000 [0x6007].
I/O at 0x6100 [0x6103].
I/O at 0x6200 [0x6207].
I/O at 0x6300 [0x6303].
I/O at 0x6400 [0x643f].
Non-prefetchable 32 bit memory at 0xe0000000 [0xe001ffff].
$ cat /proc/ide/pdc2002xx
PDC20262 Chipset.
------------------------------- General Status ---------------------------------
Burst Mode : enabled
Host Mode : Normal
Bus Clocking : 33 PCI Internal
IO pad select : 4 mA
Status Polling Period : 0
Interrupt Check Status Polling Delay : 2
--------------- Primary Channel ---------------- Secondary Channel -------------
enabled enabled
66 Clocking enabled enabled
Mode PCI Mode PCI
FIFO Empty FIFO Empty
--------------- drive0 --------- drive1 -------- drive0 ---------- drive1 ------
DMA enabled: yes yes yes no
DMA Mode: UDMA 4 UDMA 4 UDMA 4 NOTSET
PIO Mode: PIO 4 PIO 4 PIO 4 NOTSET
$ cat /proc/ide/ide3/hdg/geometry
physical 238216/16/63
logical 238216/16/63
$ cat /proc/ide/ide3/hdg/model
Maxtor 4G120J6
$ /sbin/fdisk -l /dev/hdg
Disk /dev/hdg: 16 heads, 63 sectors, 238216 cylinders
Units = cylinders of 1008 * 512 bytes
Device Boot Start End Blocks Id System
/dev/hdg1 1 41611 20971912+ 83 Linux
/dev/hdg2 41612 83222 20971944 83 Linux
/dev/hdg3 83223 124833 20971944 83 Linux
/dev/hdg4 124834 238216 57145032 5 Extended
/dev/hdg5 124834 166444 20971912+ 83 Linux
/dev/hdg6 166445 208055 20971912+ 83 Linux
/dev/hdg7 208056 238216 15201112+ 83 Linux
^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: 2.4.19 hangs on partition table check
2002-08-05 14:59 2.4.19 hangs on partition table check bd
@ 2002-08-05 15:07 ` Tyler Longren
0 siblings, 0 replies; 2+ messages in thread
From: Tyler Longren @ 2002-08-05 15:07 UTC (permalink / raw)
To: bd; +Cc: linux-kernel
On Mon, 5 Aug 2002 16:59:54 +0200
bd@bc-bd.org wrote:
> Hi,
>
> during boot the kernel hangs when it tries to check the partition
> table of one hd, a 120GB Maxtor. The gemometry is detected right
> though and there are no problems with the 2.4.18 kernel where i used
> the same configuration as with the new kernel.
>
> the host is a i586 on a gigabyte HX motherboard and i am running
> debian testing with the latest packages.
>
> this drive (hdg) is atached to a promise66 pci card on the second
> controler(ide3) and is the only drive there. i have two other maxtors
> (60GB and 80GB) atached to the other controler (ide2). the partition
> table checks for those work fine.
>
> if you need any other information, please let me know.
>
> by
> bd
>
> $ cat /usr/src/linux/.config | grep PDC
> CONFIG_BLK_DEV_PDC202XX=y
> CONFIG_PDC202XX_BURST=y
> # CONFIG_PDC202XX_FORCE is not set
> # CONFIG_BLK_DEV_ATARAID_PDC is not set
>
> $ cat /proc/pci
> Bus 0, device 8, function 0:
> Unknown mass storage controller: Promise Technology, Inc. 20262 (rev
> 1). IRQ 11.
> Master Capable. Latency=32.
> I/O at 0x6000 [0x6007].
> I/O at 0x6100 [0x6103].
> I/O at 0x6200 [0x6207].
> I/O at 0x6300 [0x6303].
> I/O at 0x6400 [0x643f].
> Non-prefetchable 32 bit memory at 0xe0000000 [0xe001ffff].
>
> $ cat /proc/ide/pdc2002xx
> PDC20262 Chipset.
> ------------------------------- General Status
> --------------------------------- Burst Mode
> : enabled Host Mode : Normal
> Bus Clocking : 33 PCI Internal
> IO pad select : 4 mA
> Status Polling Period : 0
> Interrupt Check Status Polling Delay : 2
> --------------- Primary Channel ---------------- Secondary Channel
> -------------
> enabled enabled
> 66 Clocking enabled enabled
> Mode PCI Mode PCI
> FIFO Empty FIFO Empty
> --------------- drive0 --------- drive1 -------- drive0 ----------
> drive1 ------ DMA enabled: yes yes yes
> no
> DMA Mode: UDMA 4 UDMA 4 UDMA 4
> NOTSET PIO Mode: PIO 4 PIO 4 PIO 4
> NOTSET
>
> $ cat /proc/ide/ide3/hdg/geometry
> physical 238216/16/63
> logical 238216/16/63
>
> $ cat /proc/ide/ide3/hdg/model
> Maxtor 4G120J6
>
> $ /sbin/fdisk -l /dev/hdg
> Disk /dev/hdg: 16 heads, 63 sectors, 238216 cylinders
> Units = cylinders of 1008 * 512 bytes
>
> Device Boot Start End Blocks Id System
> /dev/hdg1 1 41611 20971912+ 83 Linux
> /dev/hdg2 41612 83222 20971944 83 Linux
> /dev/hdg3 83223 124833 20971944 83 Linux
> /dev/hdg4 124834 238216 57145032 5 Extended
> /dev/hdg5 124834 166444 20971912+ 83 Linux
> /dev/hdg6 166445 208055 20971912+ 83 Linux
> /dev/hdg7 208056 238216 15201112+ 83 Linux
>
> -
> To unsubscribe from this list: send the line "unsubscribe
> linux-kernel" in the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
This is being addressed by Alan Cox's -ac patch. Try applying
ac4, that might fix your problems.
Tyler Longren
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2002-08-05 15:04 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2002-08-05 14:59 2.4.19 hangs on partition table check bd
2002-08-05 15:07 ` Tyler Longren
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox