Re: 2.5 BK boot hang after ide

Felipe Alfaro Solana
2003-03-23T14:20:09Z

----- Original Message -----
From: Duncan Sands <baldrick@wanadoo.fr>
Date: Sun, 23 Mar 2003 14:44:21 +0100
To: alan@redhat.com
Subject: 2.5 BK boot hang after ide

> Copied down by hand:
>
> ...
> ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
> VP_IDE: IDE controller at PCI slot 00:11.1
> ACPI: No IRQ known for interrupt pin A of device 00:11.1 - using IRQ 255
> VP_IDE: Chipset revision 6
> VP_IDE: not 100% native mode: will probe irqs later
> ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
> VP_IDE: VIA vt 8235 (rev 00) IDE UDMA 133 controller on pci00:11.1
> ide0: BM_DMA at 0xfc00-0xfc07, BIOS settings: hda: DMA, hdb: DMA
> ide1: BM_DMA at 0xfc08-0xfc0f, BIOS settings: hdc: DMA, hdd: DMA
> hda: ST320423A, ATA DISK drive
> hdb: Maxtor 6E030L0, ATA DISK drive
> id0 at 0x1f0-0x1f7, 0x3f6 on irq 14
> hdc: TOSHIBA DVD-ROM SD-MI402, ATAPI CD/DVD-ROM drive
> hdd: LG CD-RW CED-8080B, ATAPI CD/DVD-ROM drive
> ide1 at 0x170-0x177, 0x376 on irq 15
> hda: host protected area => 1
> hda : 40011300 sectors (20486 MB) w/512KiB Cache, CHS=39693/16/63, UDMA(66)
> hda: hda1 hda2 hda3
> hdb: host protected area => 1
> hdb : 60058656 sectors (30750 MB) w/2048KiB Cache, CHS=59582/16/63, UDMA(133)
> hdb: hdb1
> (hangs)

I'm experiencing exactly the same as you: 2.5 won't
continue past IDE. I've tried 2.5.65-ac3, 2.5.65-bk3
and 2.5.65-mm4. All of them fail at the same point.
I've tried using ACPI, APM, disabling preempt, TCQ,
enabling SysRq support, but had no luck.

The machine is a Pentium 4 2.0Gz, with a QDI
PlatiniX 2D/533-A (i845E), 2 UDMA100 disks
(Seagate ST380021A 80GB and IBM-DTLA-307030
20GB), a Pioneer DVD-ROM and Sony CRX185E3).

--
______________________________________________
http://www.linuxmail.org/
Now with e-mail forwarding for only US$5.95/yr