From: Michael Frank <mhf@linuxmail.org>
To: Vojtech Pavlik <vojtech@suse.cz>
Cc: Vojtech Pavlik <vojtech@suse.cz>,
mru@users.sourceforge.net, linux-kernel@vger.kernel.org
Subject: Re: [BUG?] SIS IDE DMA errors
Date: Sat, 27 Sep 2003 14:40:12 +0800 [thread overview]
Message-ID: <200309271440.12958.mhf@linuxmail.org> (raw)
In-Reply-To: <20030927061342.GA14652@ucw.cz>
On Saturday 27 September 2003 14:13, Vojtech Pavlik wrote:
> On Sat, Sep 27, 2003 at 03:19:37AM +0800, Michael Frank wrote:
>
> > > > 00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev d0) (prog-if 80 [Master])
> > > > Subsystem: Asustek Computer, Inc.: Unknown device 1688
> > > > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
> > > > Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> > > > Latency: 128
> > > > Region 4: I/O ports at b800 [size=16]
> > > > 00: 39 10 13 55 07 00 00 00 d0 80 01 01 00 80 80 00
> > > > 10: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
> > > > 20: 01 b8 00 00 00 00 00 00 00 00 00 00 43 10 88 16
> > > > 30: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
> > > > 40: 31 81 00 00 31 85 00 00 08 01 e6 51 00 02 00 02
> > >
> > > Ok, this means:
> > >
> > > 31 - hda: 90ns data active time, 30 ns data recovery time (PIO4)
> > > 41 - hda: UDMA enabled, UDMA mode 5 (UDMA100)
> > > 00 - hdb: 240ns/360ns (PIO0) - no drive present
> > > 00 - hdb: UDMA disabled
> > > 31 - hdc: 90ns/30ns PIO4
> > > 85 - hdc: UDMA enabled, UDMA mode 2 (UDMA33)
> > > 00 - hdd: 240ns/360ns (PIO0) - no drive present
> > > 00 - hdd: UDMA disabled
> >
> 1) You're looking at your ethernet controller config registers,
> not at the IDE controller config registers.
Oooooooooops, pasted the wrong one - was 3am ;)
Here it is with 2.4.22:
00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (prog-if 80 [Master])
Subsystem: Micro-Star International Co., Ltd.: Unknown device 5332
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 128
Interrupt: pin ? routed to IRQ 10
Region 4: I/O ports at 4000 [size=16]
Capabilities: [58] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00: 39 10 13 55 05 00 10 02 00 80 01 01 00 80 00 00
10: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
20: 01 40 00 00 00 00 00 00 00 00 00 00 62 14 32 53
30: 00 00 00 00 58 00 00 00 00 00 00 00 00 00 00 00
40: 00 00 00 00 00 00 00 00 00 00 06 00 00 00 00 00
50: f2 07 f2 07 ea 96 d5 d0 01 00 02 86 00 00 00 00
60: ff aa ff aa 00 00 00 00 00 00 00 00 00 00 00 00
70: 17 21 06 04 00 60 1c 1e 00 60 1c 1e 00 60 1c 1e
80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
2.6.0-test5 is same
Regards
Michael
next prev parent reply other threads:[~2003-09-27 6:40 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2003-09-26 12:30 [BUG?] SIS IDE DMA errors Måns Rullgård
2003-09-26 14:08 ` Michael Frank
2003-09-26 14:07 ` Måns Rullgård
2003-09-26 15:32 ` Michael Frank
2003-09-26 15:38 ` Måns Rullgård
2003-09-26 19:44 ` Michael Frank
2003-09-29 9:23 ` Måns Rullgård
2003-09-29 13:12 ` Michael Frank
2003-09-26 16:59 ` Vojtech Pavlik
2003-09-26 17:27 ` Måns Rullgård
2003-09-26 17:53 ` Vojtech Pavlik
2003-09-26 17:46 ` Måns Rullgård
2003-09-26 18:33 ` Vojtech Pavlik
2003-09-26 19:19 ` Michael Frank
2003-09-27 6:13 ` Vojtech Pavlik
2003-09-27 6:40 ` Michael Frank [this message]
2003-09-29 9:22 ` Måns Rullgård
2003-09-29 10:01 ` Vojtech Pavlik
2003-10-02 0:32 ` Michael Frank
2003-09-26 18:29 ` Michael Frank
2003-09-29 11:18 ` Lionel Bouton
2003-09-26 18:15 ` Michael Frank
2003-09-26 18:22 ` Michael Frank
2003-10-03 8:38 ` [BUG?] lost interrupt (was: SIS IDE DMA errors) David Caldwell
2003-10-03 9:08 ` [BUG?] lost interrupt Måns Rullgård
2003-10-03 20:07 ` David Caldwell
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200309271440.12958.mhf@linuxmail.org \
--to=mhf@linuxmail.org \
--cc=linux-kernel@vger.kernel.org \
--cc=mru@users.sourceforge.net \
--cc=vojtech@suse.cz \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox