From: Adrian Bunk <bunk@fs.tum.de>
To: Francois Romieu <romieu@fr.zoreil.com>,
Donald Becker <becker@scyld.com>,
linux-net@vger.kernel.org, jgarzik@pobox.com,
linux-kernel@vger.kernel.org
Subject: Re: Problem with 2.4.22 and SMC EtherPower II 9432
Date: Mon, 20 Oct 2003 23:49:27 +0200 [thread overview]
Message-ID: <20031020214927.GV23191@fs.tum.de> (raw)
In-Reply-To: <20031020233045.A14712@electric-eye.fr.zoreil.com>
On Mon, Oct 20, 2003 at 11:30:45PM +0200, Francois Romieu wrote:
> Adrian Bunk <bunk@fs.tum.de> :
> [...]
> > on two different machines the ethernet card works with kernel 2.2.20 but
> > not with kernel 2.4.22 (both contain machines contain the same card).
>
> Could you display the registers with the utility available at
> <URL:ftp://ftp.scyld.com/pub/diag/epic-diag.c> ?
(kernel 2.2.20)
# epic-diag -aa -ee -mm
epic-diag.c:v2.01 1/6/2000 Donald Becker (becker@scyld.com)
http://www.scyld.com/diag/index.html
Index #1: Found a SMSC EPIC/100 83c170 adapter at 0xb000.
The EPIC/100 chip appears to be active, so some registers will not be
read.
To see all register values use the '-f' flag.
EPIC chip registers at 0xb000
0x000: 00000008 00240000 000013bf 00000712 00004831 00000061 00000000 00000000
0x020: 00000000 00000000 00000000 00007589 00000610 0000782d 00003816 00003c60
0x040: 0000e000 00003d29 00006fe4 00006700 0000ffff 0000ffff 0000ffff 0000ffff
0x060: 0000000c ******** ******** ******** 00003c7f 00002003 ******** ********
0x080: ******** 0048b810 ******** ******** ******** ******** ******** ********
0x0A0: ******** 005a0801 ******** ******** 005a0bfd ******** ******** ********
0x0C0: ******** 0048baa0 ******** ******** ******** ******** ******** 0048b900
0x0E0: ******** ******** ******** ******** ******** ******** ******** ********
No interrupt sources are pending.
Rx state is 'Running', Tx state is 'Idle'.
Transmitter: slot time 512 bits, full-duplex mode.
Last transmit OK, 0 collisions.
Receiver control is 000c, multicast mode.
The last Rx frame was 90 bytes, status 1.
EEPROM contents (size: 64x16):
e000 3d29 6fe4 6700 0001 1c08 10b8 a014
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0010 0000 1980 2100 0000 0000 0003 0000
0701 0000 0000 0000 4d53 3943 3334 5432
2058 2020 0000 0000 0280 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
The word-wide EEPROM checksum is 0x536a.
Parsing the EEPROM of a EPIC/100:
Station Address 00:E0:29:3D:E4:6F.
Board name 'SMC9432TX ', revision 0.
Calculated checksum is 00, correct.
Subsystem ID Vendor/Device 10b8/a014.
MII PHY found at address 3.
MII PHY #3 transceiver registers:
3000 782d 0181 4401 01e1 45e1 0001 ffff
ffff ffff ffff ffff ffff ffff ffff ffff
0040 0018 ffff ffff ffff ffff ffff ffff
ffff ffff ffff 003e ffff 0048 0000 1dd8.
MII PHY #3 transceiver registers:
3000 782d 0181 4401 01e1 45e1 0001 ffff
ffff ffff ffff ffff ffff ffff ffff ffff
0040 0018 ffff ffff ffff ffff ffff ffff
ffff ffff ffff 003e ffff 0048 0000 1dd8.
Basic mode control register 0x3000: Auto-negotiation enabled.
Basic mode status register 0x782d ... 782d.
Link status: established.
Capable of 100baseTx-FD 100baseTx 10baseT-FD 10baseT.
Able to perform Auto-negotiation, negotiation complete.
Vendor ID is 00:60:51:--:--:--, model 0 rev. 1.
Vendor/Part: Quality Semiconductor (unknown type).
I'm advertising 01e1: 100baseTx-FD 100baseTx 10baseT-FD 10baseT
Advertising no additional info pages.
IEEE 802.3 CSMA/CD protocol.
Link partner capability is 45e1: Flow-control 100baseTx-FD 100baseTx 10baseT-FD 10baseT.
Negotiation completed.
Monitoring the MII transceiver status.
23:44:07.609 Baseline value of MII BMSR (basic mode status register) is 782d.
> Ueimor
cu
Adrian
--
"Is there not promise of rain?" Ling Tan asked suddenly out
of the darkness. There had been need of rain for many days.
"Only a promise," Lao Er said.
Pearl S. Buck - Dragon Seed
next prev parent reply other threads:[~2003-10-20 21:53 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2003-10-20 20:59 Problem with 2.4.22 and SMC EtherPower II 9432 Adrian Bunk
2003-10-20 21:30 ` Francois Romieu
2003-10-20 21:49 ` Adrian Bunk [this message]
2003-10-20 22:14 ` Andreas Steinmetz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20031020214927.GV23191@fs.tum.de \
--to=bunk@fs.tum.de \
--cc=becker@scyld.com \
--cc=jgarzik@pobox.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-net@vger.kernel.org \
--cc=romieu@fr.zoreil.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox