VIA Rhine WOL

VIA Rhine WOL

[Roger Luethi]

I got quite a few reports regarding WOL and via-rhine. Here's some
information so people can find it:

Rhine hardware can often do WOL without any support from the operating
system, i.e. the hardware will wake-up upon receiving a magic packet
even if you have no OS installed. That's meant for legacy OSes like DOS.

A WOL-aware OS has a more fine-grained control over Rhine WOL. For one,
it can turn WOL off. It can also configure the type of events that will
wake the system.

The via-rhine code has changed in the 2.6.9/2.6.10 time frame: Legacy
WOL is turned off (mostly), so it will not work unless you explicitly
tell the driver to enable WOL. You can do this using ethtool(8).

If WOL used to work with your Rhine hardware and now all of a sudden
doesn't, check first if you enabled WOL using ethtool.

Roger

Re: VIA Rhine WOL

[Sven Ladegast]

On Thursday 18 November 2004 19:10, Roger Luethi wrote:

> The via-rhine code has changed in the 2.6.9/2.6.10 time frame: Legacy
> WOL is turned off (mostly), so it will not work unless you explicitly
> tell the driver to enable WOL. You can do this using ethtool(8).
>
> If WOL used to work with your Rhine hardware and now all of a sudden
> doesn't, check first if you enabled WOL using ethtool.
>
> Roger

That was the information I needed... :o)
I just wondered why my machine did not want to wake up.

Sven
-- 
Sven Ladegast, Friedrich-Fröbel-Straße 11, 93310 Arnstadt / Germany
Phone: +49-175-5334308, PGP-key: 0x5856A5ED