[2.6 patch] drivers/block/cpqarray.c: small cleanups

[Adrian Bunk <bunk@stusta.de>]

The patch below contains the following cleanups:
- make cpqarray_pci_device_id static
- merge cpqarray_init_step2 into cpqarray_init and make it static


 drivers/block/cpqarray.c |   13 ++-----------
 1 files changed, 2 insertions(+), 11 deletions(-)


Signed-off-by: Adrian Bunk <bunk@stusta.de>

--- linux-2.6.10-rc1-mm3-full/drivers/block/cpqarray.c.old	2004-11-06 19:51:42.000000000 +0100
+++ linux-2.6.10-rc1-mm3-full/drivers/block/cpqarray.c	2004-11-06 19:53:16.000000000 +0100
@@ -97,7 +97,7 @@
 };
 
 /* define the PCI info for the PCI cards this driver can control */
-const struct pci_device_id cpqarray_pci_device_id[] =
+static const struct pci_device_id cpqarray_pci_device_id[] =
 {
 	{ PCI_VENDOR_ID_DEC, PCI_DEVICE_ID_COMPAQ_42XX,
 		0x0E11, 0x4058, 0, 0, 0},       /* SA431 */
@@ -135,7 +135,6 @@
 /* Debug Extra Paranoid... */
 #define DBGPX(s) do { } while(0)
 
-int cpqarray_init_step2(void);
 static int cpqarray_pci_init(ctlr_info_t *c, struct pci_dev *pdev);
 static void __iomem *remap_pci_mem(ulong base, ulong size);
 static int cpqarray_eisa_detect(void);
@@ -312,14 +311,6 @@
 
 module_param_array(eisa, int, NULL, 0);
 
-/* This is a bit of a hack,
- * necessary to support both eisa and pci
- */
-int __init cpqarray_init(void)
-{
-	return (cpqarray_init_step2());
-}
-
 static void release_io_mem(ctlr_info_t *c)
 {
 	/* if IO mem was not protected do nothing */
@@ -560,7 +551,7 @@
  *  This is it.  Find all the controllers and register them.
  *  returns the number of block devices registered.
  */
-int __init cpqarray_init_step2(void)
+static int __init cpqarray_init(void)
 {
 	int num_cntlrs_reg = 0;
 	int i;