Re: saa7134 card no longer working

[Adrian Bunk <bunk@stusta.de>]

FYI:
This problem is fixed in 2.6.13-rc2-mm2.


On Sun, Jul 10, 2005 at 06:58:39PM +0200, Adrian Bunk wrote:
> Hi,
> 
> I observed the following problem with a Tevion MD 9717 card:
> 
> It works in 2.6.12-rc6-mm1, but AFAIR this was the last kernel where it 
> worked, in more recent kernels (including 2.6.13-rc2-mm1) tvtime only 
> says "no signal".
> 
> dmesg output with 2.6.12-rc6-mm1:
> saa7134[0]: found at 0000:00:0a.0, rev: 1, irq: 6, latency: 32, mmio: 0xcfffcc00
> saa7134[0]: subsystem: 1131:0000, board: Tevion MD 9717 [card=6,insmod option]
> saa7134[0]: board init: gpio is 100a0
> saa7134[0]: Huh, no eeprom present (err=-5)?
> saa7134[0]: registered device video0 [v4l2]
> saa7134[0]: registered device vbi0
> saa7134[0]: registered device radio0
> tuner 4-0060: chip found @ 0xc0 (saa7134[0])
> tuner 4-0060: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
> 
> In 2.6.13-rc2-mm1 there's an additional line
> tuner 4-0060: All bytes are equal. It is not a TEA5767
> 
> I'm always saying "saa7134.card=6" at the kernel command line since I 
> got a "no eeprom present" message from the driver without this.
> 
> The card is working with 2.6.12-rc6-mm1, but during running, I 
> occasionally get the following message in the syslog:
> saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [last detected]
> 
> cu
> Adrian