Re: 2.6.13-rc3-mm3

[Andrew Morton <akpm@osdl.org>]

Michael Thonke <tk-shockwave@web.de> wrote:
>
> Andrew Morton schrieb:
> > Michael Thonke <iogl64nx@gmail.com> wrote:
> >> here again I have two problems. With 2.6.13-rc3-mm3 I have problems 
> >>  using my SATA drives on Intel ICH6.
> >>  The kernel can't route there IRQs or can't discover them. the option 
> >>  irqpoll got them to work now.
> >>  The problem is new because 2.6.13-rc3[-mm1,mm2] work without any problems.
> > 
> > OK.  Please generate the full dmesg output for -mm2 and for -mm3 and run
> > `diff -u dmesg.mm2 dmesg.mm3' and send it?  And keep those files because we
> > may end up needing to add them to an acpi bugzilla entry ;)
> 
> Well I did a little mistake..it only worked correctly up to
> 2.6.13-rc3-mm1 but this dmesg output I have.
> 
> Well as I save mm[2,3] are unable to setup the correct IRQs for the
> devices..and please note that 2.6.13-rc3-mm3 only booted with irqpoll so
> its in the dmesg output "dmesg.mm3"
> Normaly the IRQ routed to something about 1xx now they are 1-21?! Caused
> by irqpoll?
> 

Are these problems only present in -mm kernels?  Does 2.6.13-rc4 work OK?

> > Odd trace.  Do you have CONFIG_KALLSYMS enabled?  If not, please turn it on.
> 
> Mh I tried but my system freezes on boot then. And screen leaves blank.
> > 

Oh geeze.

@@ -53,10 +23,18 @@
 Enabling fast FPU save and restore... done.
 Enabling unmasked SIMD FPU exception support... done.
 Checking 'hlt' instruction... OK.
+    ACPI-0287: *** Error: Region SystemMemory(0) has no handler
+    ACPI-0127: *** Error: acpi_load_tables: Could not load namespace: AE_NOT_EXIST
+    ACPI-0136: *** Error: acpi_load_tables: Could not load tables: AE_NOT_EXIST
+ACPI: Unable to load the System Description Tables
 ENABLING IO-APIC IRQs
-..TIMER: vector=0x31 pin1=2 pin2=0
+..TIMER: vector=0x31 pin1=2 pin2=-1
 NET: Registered protocol family 16
 PCI: Using configuration type 1
+ACPI: Subsystem revision 20050708
+ACPI: Interpreter disabled.

Well it looks like ACPI committed suicide, so there's probably not much
point looking at the other things until that gets addressed.

Would you have time to raise a kernel bugzilla entry for this?  Raise it
against the ACPI AML interpreter, version 20050708 and mention the above
failure.  The output of acpidump (from
ftp://ftp.kernel.org/pub/linux/kernel/people/lenb/acpi/utils/pmtools-20050727.tar.gz)
will probably be asked for.

Thanks.