Re: Could not suspend device [VIA UHCI USB controller]: error -22

[Greg KH <greg@kroah.com>]

On Sun, Jan 02, 2000 at 11:28:12AM +0300, Michael Tokarev wrote:
> Greg KH wrote:
> >On Sun, Dec 04, 2005 at 03:12:41AM +0300, Michael Tokarev wrote:
> >
> >>When I try to "standby" (echo standby > /sys/power/state)
> >>a 2.6.14 system running on a VIA C3-based system with VIA
> >>chipset (suspend to disk never worked on this system --
> >>as stated on swsusp website it's due to the lack of some
> >>CPU instruction on this CPU [but winXP suspends to disk
> >>on this system just fine]), it immediately comes back, with
> >>the above error message:
> >
> >Can you try 2.6.15-rc4 or newer to see if that fixes this issue for you?
> 
> Yes, 2.6.15-rc4 restores previous functionality - the error in
> $subject is now gone, and it seems the system goes to standby
> as it should, without errors and 'standby process interruptions'.
> Thanks.
> 
> With the only problem which was here all the time - it comes "back
> to C" after less a secound all the disks/monitor/etc are placed
> into sleep mode..  Ie,
> 
>  ..preparing for standby...
>  ..hdd stops spinning..
>  ..monitor is turned off..
>  ..less-than-a-secound-pause..
>  Back to C!
>  ..the system goes back, restoring interrupts etc...
> 
> I tried various 'wakeup' settings in bios, incl. turning everything
> off in that menu - no difference.
> 
> The same behaviour is shown by all 2.6 kernels I tried so far
> (since 2.6.6 or so).

Does normal "suspend" work for you on this machine (echoing "disk" to
that sysfs file?)

I'd suggest creating a bugzilla.kernel.org entry for this new problem.

thanks,

greg k-h