Modprobe sd_mod question?

Modprobe sd_mod question?

[Nick Warne]

Hi all,

I am getting this FATAL when I plug in my usb memory stick  - everything all 
works though:


Mar 21 18:02:51 linuxamd kernel: usb 2-1.2: new full speed USB device using 
uhci_hcd and address 6
Mar 21 18:02:52 linuxamd kernel: scsi1 : SCSI emulation for USB Mass Storage 
devices
Mar 21 18:02:57 linuxamd kernel:   Vendor:           Model: USB DRIVE         
Rev: 1.13
Mar 21 18:02:57 linuxamd kernel:   Type:   Direct-Access                      
ANSI SCSI revision: 00
Mar 21 18:02:57 linuxamd kernel: SCSI device sda: 62464 512-byte hdwr sectors 
(32 MB)
Mar 21 18:02:57 linuxamd kernel: sda: Write Protect is off
Mar 21 18:02:57 linuxamd kernel: SCSI device sda: 62464 512-byte hdwr sectors 
(32 MB)
Mar 21 18:02:57 linuxamd kernel: sda: Write Protect is off
Mar 21 18:02:57 linuxamd kernel:  sda: sda1
Mar 21 18:02:57 linuxamd kernel: sd 1:0:0:0: Attached scsi removable disk sda
Mar 21 18:02:57 linuxamd kernel: sd 1:0:0:0: Attached scsi generic sg0 type 0
Mar 21 18:02:57 linuxamd modprobe: FATAL: Module sd_mod not found.
Mar 21 18:03:47 linuxamd kernel: usb 2-1.2: USB disconnect, address 6



I only have two modules - nVidia and Vicam.  Everything else is built in.



Corresponding .config

# SCSI support type (disk, tape, CD-ROM)
#
CONFIG_BLK_DEV_SD=y
# CONFIG_CHR_DEV_ST is not set
# CONFIG_CHR_DEV_OSST is not set
CONFIG_BLK_DEV_SR=y
# CONFIG_BLK_DEV_SR_VENDOR is not set
CONFIG_CHR_DEV_SG=y
# CONFIG_CHR_DEV_SCH is not set



My /etc/modprobe.conf and /etc/modules are empty.



kernel 2.6.15.6
module-init-tools version 3.0


Ideas what/why (it) is doing this probe for non-existant module?

Thanks,

Nick

-- 
"Person who say it cannot be done should not interrupt person doing it."
-Chinese Proverb