[PATCH] fix ancient breakage in ebus_init()

[Al Viro <viro@ftp.linux.org.uk>]

Back when pci_dev had base_address[], loop of form
	base = &...->base_address[0];
	for (.....) {
		...
		*base++ = addr;
	}
was fine, but when that array got spread in ->resource[...].start
replacing the initialization with
	base = &...->resource[0].start;
was not a sufficient modification.  IOW this code got broken for cases
when there had been more than one resource to fill.  All way back in
2.3.41-pre3...

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
---
 arch/sparc/kernel/ebus.c |    7 +++----
 1 files changed, 3 insertions(+), 4 deletions(-)

diff --git a/arch/sparc/kernel/ebus.c b/arch/sparc/kernel/ebus.c
index 81c0cbd..75ac24d 100644
--- a/arch/sparc/kernel/ebus.c
+++ b/arch/sparc/kernel/ebus.c
@@ -277,7 +277,7 @@ void __init ebus_init(void)
 	struct pci_dev *pdev;
 	struct pcidev_cookie *cookie;
 	struct device_node *dp;
-	unsigned long addr, *base;
+	struct resource *p;
 	unsigned short pci_command;
 	int len, reg, nreg;
 	int num_ebus = 0;
@@ -321,13 +321,12 @@ void __init ebus_init(void)
 		}
 		nreg = len / sizeof(struct linux_prom_pci_registers);
 
-		base = &ebus->self->resource[0].start;
+		p = &ebus->self->resource[0];
 		for (reg = 0; reg < nreg; reg++) {
 			if (!(regs[reg].which_io & 0x03000000))
 				continue;
 
-			addr = regs[reg].phys_lo;
-			*base++ = addr;
+			(p++)->start = regs[reg].phys_lo;
 		}
 
 		ebus->ofdev.node = dp;
-- 
1.4.2.GIT