From: Oliver Neukum <oliver@neukum.org>
To: Pavel Machek <pavel@ucw.cz>
Cc: Jeremy Maitin-Shepard <jbms@cmu.edu>,
Nick Piggin <nickpiggin@yahoo.com.au>,
Al Boldi <a1426z@gawab.com>,
linux-kernel@vger.kernel.org,
Andrew Morton <akpm@linux-foundation.org>
Subject: Re: Hibernation Redesign
Date: Mon, 9 Jul 2007 16:02:26 +0200 [thread overview]
Message-ID: <200707091602.27312.oliver@neukum.org> (raw)
In-Reply-To: <20070709134522.GA3216@elf.ucw.cz>
Am Montag, 9. Juli 2007 schrieb Pavel Machek:
> Hi!
>
> > >> This approach eliminates the need for the freezer, as it would make
> > >> hibernate look a lot a bit like suspend to ram from the perspective of
> > >> the "old" kernel (the kernel being hibernated), as the hibernate
> > >> operation itself would be completely atomic from the perspective of the
> > >> "old" kernel. That is not to say, of course, that any code paths would
> > >> actually be shared, or that the drivers would do the same things
> > >> (because they probably would not).
> >
> > > Well it basically is suspend to RAM with the additional step that a
> > > new kernel gets booted and writes out the data from RAM to disk then
> > > shuts down.
> >
> > There is the key difference, though, that the drivers should do rather
> > different things. In particular, rather than place the hardware in a
> > low-power mode, it should place it in some state such that the new
> > kernel being loaded can handle it.
>
> Actually, when current kernel restores the snapshot... driver
> requirements seem to be pretty similar. So that should not be a big
> problem.
Hm, once the new kernel is booted, this decision is irrevocable, isn't it?
Is there any way to deal with errors by handing control back?
Regards
Oliver
next prev parent reply other threads:[~2007-07-09 14:02 UTC|newest]
Thread overview: 60+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-07-08 14:37 Hibernation Redesign (was: malicious filesystems (was Re: [linux-pm] Re: [PATCH] Remove process freezer from suspend to RAM) Al Boldi
2007-07-09 4:11 ` Hibernation Redesign Jeremy Maitin-Shepard
2007-07-09 4:29 ` Nick Piggin
2007-07-09 4:36 ` Jeremy Maitin-Shepard
2007-07-09 4:45 ` Nick Piggin
2007-07-09 4:54 ` Jeremy Maitin-Shepard
2007-07-09 4:58 ` Nick Piggin
2007-07-09 5:33 ` Nick Piggin
2007-07-09 6:22 ` Jeremy Fitzhardinge
2007-07-09 13:45 ` Pavel Machek
2007-07-09 14:02 ` Oliver Neukum [this message]
2007-07-09 14:26 ` Jeremy Maitin-Shepard
2007-07-09 15:09 ` Oliver Neukum
2007-07-09 15:27 ` Jeremy Maitin-Shepard
2007-07-09 4:39 ` Nick Piggin
2007-07-09 13:52 ` Pavel Machek
2007-07-09 15:30 ` Al Boldi
2007-07-10 1:29 ` Nick Piggin
2007-07-10 2:28 ` Jeremy Maitin-Shepard
2007-07-10 14:57 ` Jeremy Fitzhardinge
2007-07-10 17:25 ` Jeremy Maitin-Shepard
2007-07-10 22:59 ` Jeremy Fitzhardinge
2007-07-11 4:11 ` Al Boldi
2007-07-11 10:27 ` Rafael J. Wysocki
2007-07-11 10:42 ` Miklos Szeredi
2007-07-11 11:04 ` Rafael J. Wysocki
2007-07-11 11:11 ` Miklos Szeredi
2007-07-11 11:50 ` Rafael J. Wysocki
2007-07-11 11:54 ` Miklos Szeredi
2007-07-11 12:00 ` Nigel Cunningham
2007-07-11 12:09 ` Miklos Szeredi
2007-07-11 12:17 ` Nigel Cunningham
2007-07-11 12:27 ` Rafael J. Wysocki
2007-07-11 12:29 ` Miklos Szeredi
2007-07-11 21:04 ` Rafael J. Wysocki
2007-07-12 9:15 ` Pavel Machek
2007-07-12 22:13 ` Miklos Szeredi
2007-07-11 12:19 ` Rafael J. Wysocki
2007-07-11 12:49 ` Nigel Cunningham
2007-07-11 21:06 ` Rafael J. Wysocki
2007-07-11 12:11 ` Nigel Cunningham
2007-07-11 12:24 ` Miklos Szeredi
2007-07-11 12:46 ` Nigel Cunningham
2007-07-11 12:55 ` Miklos Szeredi
2007-07-11 13:16 ` Jeremy Maitin-Shepard
2007-07-11 20:48 ` Mark Lord
2007-07-11 21:14 ` Rafael J. Wysocki
2007-07-11 22:17 ` Al Boldi
2007-07-11 22:34 ` Rafael J. Wysocki
2007-07-11 23:12 ` Al Boldi
2007-07-11 23:31 ` Nigel Cunningham
2007-07-12 3:11 ` Al Boldi
2007-07-12 13:20 ` Rafael J. Wysocki
2007-07-16 6:04 ` Nick Piggin
2007-07-12 20:29 ` Jeremy Maitin-Shepard
2007-07-11 23:46 ` Nigel Cunningham
2007-07-11 17:55 ` david
2007-07-11 22:54 ` Nigel Cunningham
2007-07-10 17:45 ` Al Boldi
2007-07-10 18:20 ` Jeremy Maitin-Shepard
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200707091602.27312.oliver@neukum.org \
--to=oliver@neukum.org \
--cc=a1426z@gawab.com \
--cc=akpm@linux-foundation.org \
--cc=jbms@cmu.edu \
--cc=linux-kernel@vger.kernel.org \
--cc=nickpiggin@yahoo.com.au \
--cc=pavel@ucw.cz \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox