[PATCH] Disallow truncation of files in sysfs

[Ben Hutchings <bhutchings@solarflare.com>]

sysfs allows attribute files to be truncated, e.g. using ftruncate(), with the
expected effect on their inode.   For most attributes, this doesn't change the
"real" size of the file i.e. how much can be read from it.  However, the
parameter validation for reading and writing binary attribute files is based
on the inode size and not the size specified in the file's bin_attribute, so it
can be broken by this. For example, if we try using dd to write to such a file:

# pwd
/sys/bus/pci/devices/0000:08:00.0
# ls -l config
-rw-r--r--  1 root root 4096 Feb  1 17:35 config
# dd if=/dev/zero of=config bs=4 count=1
1+0 records in
1+0 records out
# ls -l config
-rw-r--r--  1 root root 0 Feb  1 17:50 config
# dd if=/dev/zero of=config bs=4 count=1 seek=128
dd: writing `config': No space left on device
1+0 records in
0+0 records out

Also, after truncation to 0, parameter validation for read and write is
disabled.  Most bin_attribute read and write methods also validate the size and
offset, but for some this will allow out-of-range access.  This may be a
security issue, though access to such files is often limited to root.  In any
case, the validation should remain for safety's sake!)

This was previously reported in Bugzilla as bug 9867.

sysfs should ignore size changes or else refuse them (by returning -EINVAL).
This patch makes it ignore them.

Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
--- a/fs/sysfs/inode.c
+++ b/fs/sysfs/inode.c
@@ -59,6 +59,8 @@
 	if (error)
 		return error;

+	iattr->ia_valid &= ~ATTR_SIZE; /* ignore size changes */
+
 	error = inode_setattr(inode, iattr);
 	if (error)
 		return error;

-- 
Ben Hutchings, Senior Software Engineer, Solarflare Communications
Not speaking for my employer; that's the marketing department's job.