Re: [Rt2400-devel] rt2500pci: Failed to initialize hw. But works with ancient rt2500-1.1.0

[Ivo van Doorn <ivdoorn@gmail.com>]

On Monday 07 July 2008, Stefan Bauer wrote:
> Hi,
> 
> 
> I'm not able to load rt2500pci from 2.6.26-rc9 under Gentoo.
> This card currently works under Debian Etch with 2.6.18 kernel and 
> rt2500-source 1.1.0+cvs20060620-3.
> 
> lspci -vvvv
> Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)
> Subsystem: RaLink Unknown device 2560
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- 
> SERR+ FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- 
> <MAbort- >SERR- <PERR-
> Latency: 64, Cache Line Size: 64 bytes
> Interrupt: pin A routed to IRQ 185
> Region 0: Memory at fba00000 (32-bit, non-prefetchable) [size=8K]
> Capabilities: [40] Power Management version 2
> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> 
> dmesg 2.6.18
> PCI: Enabling device 0000:00:0c.0 (0110 -> 0112)
> ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 185
> rt2500 1.1.0 CVS 2005/07/10 http://rt2x00.serialmonkey.com
> 
> dmesg 2.6.26-rc9
> ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 17
> phy0: Selected rate control algorithm 'pid'
> phy0: Failed to initialize wep

Check if the arc4 and ecb modules are loaded before loading mac80211 & rt2500pci.

Ivo